![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#4
|
|||
|
|||
![]()
I have two (2) Emperor 400s now - would one Fluval 404 provide equal
filtration and biological action - I'm pretty happy with the Emperors right now - the seem to do a great job! "Amateur" wrote in message . com... "No-Name" wrote in message ... I've seen a few pictures of tanks used as a room divider - I like the look, but can't figure out how I'd handle the issue of the filters, if I'm using back-filters like the Emperor 400 - to eliminate filters on either the front or the back side of the tank, I guess I'd have to go to a sump-type system - or is there another alternative? If I go to a sump, would I have to drill the tank, or is there a provision for the suction and return tubes to go over the top of the tank at the end of the tank? Thanks for any suggestions. The most clean way to do it would be to drill the tanks, that's if they're not tempered and can be drilled. You can buy predrilled tanks. If you don't already have the tank, the all-glass 180 gallon tank would look nice. The cutout on one wall would be a little narrower than on the other wall as the built in overflow covers a few inches on each corner in what's normally the back of the tank. In my overflows on my rack system, the overflow is simply a piece of pvc tubing with vents cut in the top of the tube. The top of the pvc is about a half inch down from the top of the tank with the lowest cut about an inch beneath that. You can have another piece of pvc coming up into the tank from the bottom for the return as well. There are overflow systems that have a small box you could hang off the side of the tank that work on siphon. Or you could have a cabinet above the tank with the sump over the tank and pump up to it. This would eliminate the need to drill. Drill bits are expensive and difficult to use and I couldn't find any glass places that would take the responsibility of drilling a tank for me. The other option is a canister filter like the fluval 404. You could set one up on each end. Depending on how the tank was stocked, that would probably keep up with most of your filtration needs. Amateur www.amateurcichlids.com |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
HELP massive fish die-off | Bill K | General | 7 | July 23rd 04 01:40 PM |
what to look for in new tank? | sophie | General | 15 | June 16th 04 07:57 PM |
Standpipe or something else? | Kudzu | General | 6 | February 16th 04 04:11 AM |
anaerobic filter after long power out ;( | Iain Miller | General | 15 | August 16th 03 01:57 PM |
New tank. What is a cycle? | Telemundo | General | 12 | July 28th 03 11:40 PM |