![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
Hello, I am planning to buld my first pond.
9'x14' and 2' deep with a 15 foot waterfall/stream running down to it. You can get a pretty good idea for my design so far from here http://www.woosworld.net/pond/ I am planning to put my bottom drain to my skimmer (homemade) and gravity feed the water from the bottom drain to the skimmer and from there to the pump, where it will be pumped up the hill to the top of the waterfall.. Any thoughts? I may need more filters someday, and I am also concerned that my pump may not put enough water over the falls to make it look quite right - it's a Supreme 3600 rated for a bit over 2200GPH at the head height I am going to need from it. Thanks Josh |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
been away for a long time, tank design help | Benthic | Plants | 0 | October 22nd 03 02:28 AM |
help critique my plumbing/sump design | Jeff Bartig From: | Reefs | 1 | August 29th 03 08:39 PM |