|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 3rd 04, 01:33 AM
|
|||
|
|||
Help with calcium reactor...
I have a CanReef reactor. Lately it has not be going on becuase my Ph is not
swinging much at all. I have the CO2 turning on at 8.2. But I have not seen the PH go higher than 8.1. Maybe becuase of all of the hair algae???) The reactor used to work very well. I do NOT feel this is a reactor issue, as it is not being cycled on. More of a chemical issue. Ammonia: 0.15 Ph 8.1 NO2 0.0 NO3 0.0 CA 305 Magnisium 870 PO4 0 Alk read normal (LOW/HI/NORMAL test kit.) What do you recommend? Thanks Mc 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Calcium reactor considerations | Christ's Soldiers | Reefs | 4 | February 17th 04 07:20 AM |
| Bubble Rate in Calcium Reactor | MarkW | Reefs | 4 | January 8th 04 06:00 PM |
| Bubble Rate of Calcium Reactor | MarkW | Reefs | 0 | January 7th 04 06:36 PM |
| Azoo Twin Calcium Reactor | B | Reefs | 6 | December 28th 03 09:59 PM |
| Calcium reactor maxed out? | Timothy Tom | Reefs | 2 | November 22nd 03 03:20 AM |
Threaded Mode