|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 7th 04, 01:54 PM
|
|||
|
|||
Metal Stand Help
Hi, I just got a new metal stand and the top looks like it is bowed
down in the middle. Should I straighten it? I am going to add leg adjusters on the for corners. My last tank blew a seal on the back middle, it split the silicone right in half, I'm not sure if this was caused by the stand or not. The tank was pretty level. My new tank is a 135 gallon, 72' x 18" x 24". Should I put a piece of stryofoam undet the tank? Thanks Cel 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 175 metal halide retro | gofaster | Marketplace | 0 | July 8th 04 02:17 AM |
| How many watts per gallon with metal halide lighting | Scott Rogahn | Plants | 1 | May 30th 04 12:36 PM |
| Metal Halide Pendant Lighting | Ian | Plants | 5 | December 23rd 03 02:24 AM |
| 400 Watt Metal Halide ~too much? | John Little | Plants | 1 | December 15th 03 10:05 PM |
| metal halide wattage question have 175 w fixture, can i use less wattage bulb? | Steve Sells | Reefs | 1 | November 16th 03 03:40 AM |
Threaded Mode