|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#3
January 9th 05, 02:48 AM
|
|||
|
|||
"Bill Stock" wrote in message news  "Nitesbane" wrote in message news:Bm_Dd.512$7b.471@trndny05... I just set up a CO2 system using a Dupla regulator. The pressure reading is bar pressure, not PSI and when I first hooked it up it was at 40 bar. It has been climbing slowly since I hooked it up yesterday and is now a little less than 50. The gauge says the optimal pressure should be between 60 and 80. What, if anything, should I do? Should I be worried? Was the tank cold when you took the first reading? Freezing. Still is, in fact. It's been well over 24 hours. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Throttle a pump harmful? | Ross Bagley | Reefs | 38 | March 11th 04 05:11 PM |
| No Better RO/DI Anywhere!!! | Pat Hogan | General | 0 | November 14th 03 05:57 PM |
| RO pressure booster pump | Pszemol | Reefs | 31 | November 10th 03 02:11 AM |
| High Ammonia Readings -test kits/ammonia removers | Spark_001 | General | 0 | September 27th 03 05:46 PM |
| Overdriving NO Tubes | Mort | Reefs | 63 | September 17th 03 04:09 AM |
Threaded Mode