|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
|
Thread Tools | Display Modes |
|
|
|
#1
July 15th 05, 03:27 PM
|
|||
|
|||
"miskairal" wrote in message u...
Why do you assume I am in America? If I were to buy a heater from an american website the cost of getting it to Oz would be ridiculous. I did not know what Oz is... :-) Thats why. I am not in a very cold climate. If one heater fails my tank is not going to chill down to undesirable levels before I can get another. The trick with two heaters does not work only to prevent chill downs. It also prevents boiling fish when the heater stucks in on position. Think about this one, too. 
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| DIY substrate heating & a couple other things | Bob | Plants | 2 | December 28th 03 07:21 AM |
| Do I need substrate heating cables? | [email protected] | Plants | 8 | October 7th 03 12:03 AM |
| Substrate Heating | Boris | Plants | 4 | October 2nd 03 09:09 PM |
| DIY Heating for Sump system | The Madd Hatter | Tech | 7 | August 21st 03 12:51 AM |
| Custom sealife britelite ballast failure do to over heating? | LeighMo | Plants | 1 | July 28th 03 04:47 AM |
Hybrid Mode
