|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 16th 04, 04:18 AM
|
|||
|
|||
Substrate heater installation?
I have a 20w Tunze substrate heater. I planned to put a layer of tiny gravel around it, then Fluorite on top, then some more gravel. Maybe I could pack Fluorite around the heater then gravel on top? (A response on this NG told me it should be 50/50 Fluorite/gravel, which I guess I'll stick too.) 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Which heaters are solid state and heater recommendations | Harry Muscle | Tech | 2 | February 5th 04 01:49 AM |
| Submersable Heater Melted. | Glenn Serpas | General | 2 | December 31st 03 06:19 PM |
| Substrate covering LR question | Mark Breithaupt | Reefs | 1 | November 24th 03 08:20 PM |
| Is it safe to hide the heater in a plastic tube on the inlet flow ? | Alan Silver | General | 7 | September 15th 03 05:04 PM |
| Heated substrate? Cable heaters? | Tasslehoff | Plants | 0 | July 4th 03 06:29 AM |
Threaded Mode