If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
[Q] windows tint coating uniformity at frit area
The tint film is not well stuck on the glass between dots on the frit
area of my car windows. At some area, it's seamlessly coated, but elsewhere it's not, so it's clearly noticeable even from a distance. 1. Would it do more harm than good (for example, adhesive residue, scratch on glasses, toxic adhesive removal agent if any, etc.) to remove the film and tint again? 2. Or is it possible to fix it without removing the film? 3M film with lifetime warrany was used and I paid $225 for my wagon's 5 back windows at a tint shop in Santa Clara, California. The car dealershop referred the shop since the dealershop doesn't do it by themselves. When I picked up my car at the tint shop, I noticed it but the shop told me it would take upto 5 days to dry up and then it would disappear. They also told me to visit the shop again if it persists. Advise appreciated. |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
windows tint coating uniformity at frit area | [email protected] | Technology | 2 | January 12th 07 04:27 AM |