|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
December 12th 04, 11:22 PM
|
|||
|
|||
Steering lock stopped working
The steering lock on my 523 has stopped enaging after the ignition key has
been removed. Has anyone experienced a similar problem and what was the solution? 
|
| Ads |
|
#2
December 14th 04, 12:14 PM
|
|||
|
|||
|
"John Graves" > wrote in message
... > The steering lock on my 523 has stopped enaging after the ignition key has > been removed. Has anyone experienced a similar problem and what was the > solution? I'd experience this in a Mazda. I don't remember but WD-40 and some fiddling or hammering seemed to work. Deja vu.
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Steering lock problems | John Graves | BMW | 2 | December 14th 04 02:53 PM |
| Blower on E39 stopped working | AlanG | BMW | 5 | October 31st 04 11:56 AM |
| 1991 BMW 325iX - Steering Problem | VSAndrew | BMW | 7 | October 19th 04 02:03 PM |
| '94 318is-clock And Temp Guage Has Stopped Working | ultraviolet353 | BMW | 0 | October 6th 04 01:37 AM |
| Alfa 156 engine stalls when steering is at full lock and car is stationary ! | John | Alfa Romeo | 3 | September 10th 04 03:20 PM |
Linear Mode
