If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
What doee one call this?
On Sunday, October 19, 2014 7:59:50 PM UTC-5, Steve W. wrote:
> Stormin Mormon wrote: > > > On 10/19/2014 6:40 PM, Steve W. wrote: > > >> I have two of the HF vinyl covered foam "mechanics pads". They are one > > >> of the best items I've ever bought from any tool outfit. > > >> > > >> http://www.harborfreight.com/folding...pad-93896.html > > >> > > >> I have one with a headrest and an earlier one without. Both are REAL > > >> handy items. > > > > > > Closest to that in my kit is a carpet sample for > > > five bucks (coffee money) from a carpet place. > > > That does look useful, though. Thanks for the > > > link. > > > > > > > > > > It is one of those "Why wasn't this on a tool truck years ago" items. > > Easy to wipe clean, doesn't absorb anything that I've found yet. I've > > used it on gravel, concrete, out in Vince's yard and more and no damage > > at all. > > > > -- > > Steve W. I once cut a hole in one (corrugated plastic sign) to fit around the brim of my hat to use as an extra wide 'umbrella'. It worked like a charm. |
Ads |
#12
|
|||
|
|||
What doee one call this?
On Sat, 18 Oct 2014 22:32:58 +0000 (UTC), Tegger >
wrote: >micky > wrote in : > >> What do you call the material that all those signs strapped to >> tellephone poles and on wires stuck in the ground are made of? By >> people who have no respect for public property. They start off as >> white, two layers with parallel "ribs" of the same material between the >> two outer layers every eighth of an inch. Do you know what I mean? > > > >Generically, it's called "corrugated plastic", and is usually made of >polypropylene. > >It comes in sizes that refer to the overall thickness, expressed in Metric. >The most common size is 4mm. > >"Coroplast" is one just brand. More he >http://en.wikipedia.org/wiki/Corrugated_plastic Two more good uses for corrugated plastic: 2) When digging a hole, put the dirt on the plastic so it doesn't make a mess. Later, you can pick up the plastic from the sides and carry all the dirt at one time. 2) As a pattern for making a replacement rear window for my convertible. I was going to just make a paper pattern and transfer the pattern to the Lexan, but halfway through I realized the pattern has to be verified**, so I used duck tape to tape two of my biggest pieces of coroplast togeher side by side, and transferred the paper pattern to the coroplast, which was stiff enough to insert where the window goes. I made it bigger than needed on purpose, but it's still been a challenge trimming it down. All the sides are curved to some extent, and the upper corners even more so. Also, the "glass", the plastic, has to be small enough top to bottom to fit in the well behind the back seat. I couldn't check that properly with a paper pattern. And it should only be as wide as the glass that broke was. Again, paper wouldn't do a good job. I'm still trimming the coroplast and I havent' started cutting the Lexan. I hope it fits. **Because onc |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Last call | FolkGT | Simulators | 0 | October 26th 12 06:03 PM |
to call or not to call | not much of anyone | Driving | 10 | July 17th 08 04:05 AM |
O.T. $10,000 call | FrankW | Jeep | 2 | February 28th 08 11:56 AM |
What do you call... | Scott H | VW air cooled | 3 | May 21st 05 03:29 PM |
A call to pen | James Hilins | Jeep | 0 | February 16th 05 12:20 PM |