If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Trans project underway
Hi All,
I thought I might mention as there were some folks interested, but I started the trans R&R on my project van yesterday. I got the crossmember and PTU out yesterday, the next step is the trans itself, today. No real problems although I was not impressed to find out that you have to drop the crossmember in order to change the passenger side half-shaft on the AWD models! Amazingly stupid since the interference from the crossmember is only about a half inch, they could have easily designed in a dimple that would have allowed it. Ted |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Project minivan for $200 - needs transmission | Ted Mittelstaedt | Chrysler | 6 | July 25th 05 11:04 PM |
Road recordings for Kerouac Project | [email protected] | Driving | 0 | April 1st 05 09:58 AM |
GM trans rebuild, low pressure and slipping in R and 1ST related? | andy everett | Technology | 0 | December 14th 04 12:59 AM |
95 sl2 automatic - post diyer trans r&r | Dave V | Saturn | 4 | September 2nd 04 04:37 AM |
Toyota A-340E trans problems - possible causes outside the trans? | Doc | General | 6 | May 27th 04 03:54 PM |