If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
truck stalls out
i have a 1997 ford ranger , 4 cyl, stick with a/c. 58k milages. started
stalling out since i had new belt installed. engine has self tensioner. stalls when braking. hot, cold, engine, same thing. stalls when slowing down to turn. i can eliminate stall sometines if i put stick into neutral and coast around turns or to a slow stop. does anyone have an idea what is causing this.. |
Ads |
#2
|
|||
|
|||
Poss. brake booster or something vacume. run a diagnostic to see if it
brings up any codes.changing belts should have nothing to do with it really. what happened to the old belt? did you just replace it because of wear or did it break or was cut/shredded? if this was the circumstance something has to be out of wack to cause the belt to cut/shred. |
#3
|
|||
|
|||
You may have parted, loosened or cracked a vacuum hose or line while
playing with the belt job, causing excessive vacuum drop when you also use the brakes. Try inspecting all vacuum connections & listening for leaks while it idles. Could also have a fooked brake booster, less likely at 58k. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
1991 Civic Stalls | Paul | Honda | 5 | June 14th 05 11:23 PM |
1991 Civic Stalls | Paul | Technology | 6 | June 14th 05 11:23 PM |
1978 GMC Truck - stumbles and stalls at idle | Eric Janzen | Technology | 1 | June 11th 05 01:09 PM |
Truck accident... bizarre legalities... | Goo | Driving | 4 | December 6th 04 05:06 AM |