If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
#3 misfire on 2000 SW2
I had a guy at the local AutoZone pull codes on my 2000 v-6 wagon.
I've got a couple O2 sensors out and a #3 misfire. I figure I should change the plugs. The problem is I can't even see the plugs. What's involved? I looked at a Hane's manual for the car, but it was no help glad I didn't buy it. Does anyone know where to find instructions online? I'm not willing to pay Saturn $xxx to change the plugs if I don't have to. I know I'm gonna have to buy a bunch of those fancy star shaped sockets, what are those even called? Are there plug wires that can be replaced or does each plug have its own coil? Oh, and if you've got better suggestions than replacing the plugs let me know. The engine lopes when in idle either with or without being in gear. Well thanks for your input, Paul |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
#3 misfire on 2000 SW2 | Paul[_18_] | Saturn | 14 | October 18th 07 06:59 PM |
possible causes of misfire | Robert Reynolds | Chrysler | 14 | June 1st 07 09:22 PM |
2000 Civic Misfire Even After Tune Up? | [email protected] | Honda | 4 | November 11th 06 04:29 AM |
vr6 misfire | chaseb | VW water cooled | 0 | July 19th 06 08:32 PM |
2000 Passat V6 Engine Misfire + Check Engine light | Sergio | VW water cooled | 3 | February 11th 05 06:08 PM |