If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
156 v6 24v EOBD / OBD II
I have a 1999 156 v6 Q-sys.
Can any body tell me whether it is OBD2 or EOBD compliant, as I have found out that is likely to of gone into "limp-home" mode since my earlier post! |
#2
|
|||
|
|||
It is OBD II compilant. EOBD started in 2001.
Ulrik "Jamie Chamberlain" > wrote in message ... >I have a 1999 156 v6 Q-sys. > Can any body tell me whether it is OBD2 or EOBD compliant, as I have found > out that is likely to of gone into "limp-home" mode since my earlier post! > > |
#3
|
|||
|
|||
I would disagree with that, I'm afraid. Before mid-2000 the V6 was
Alfa/Bosch specific; i.e. not even OBD-II, let alone EOBD. Same electrical connections, but very different high-level protocol. The various OBD-II software out there will not work. One app that will work - I use it on my W-reg V6 - is he http://www.alfadiag.net/ Colin "Ulrik" > wrote in message . .. > It is OBD II compilant. EOBD started in 2001. > > Ulrik > > "Jamie Chamberlain" > wrote in message > ... >>I have a 1999 156 v6 Q-sys. >> Can any body tell me whether it is OBD2 or EOBD compliant, as I have >> found >> out that is likely to of gone into "limp-home" mode since my earlier >> post! >> >> > > |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
EOBD Codes | mick | Alfa Romeo | 0 | November 21st 04 07:48 PM |