|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
January 31st 05, 04:32 AM
|
|||
|
|||
Rebuilding my 55 Chevy?
I am replacing my side window. Do the moldins get cemented in or the just
fit in with-out cement. Is there a place I can go to ask these questions as I am doing this by my self. Thank you.... 
|
| Ads |
|
#2
January 31st 05, 11:10 PM
|
|||
|
|||
|
It's been a long time since I installed them on a couple of Chevy's I own if
I remember correctly I used a small sheet metal screw to hold mine up on the top close to the vent window "Jake1955" > wrote in message lkaboutautos.com... > I am replacing my side window. Do the moldins get cemented in or the just > fit in with-out cement. > Is there a place I can go to ask these questions as I am doing this by my > self. > Thank you.... >
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 1942 Chevy Coupe | angeldelaguardia1 | Antique cars | 1 | January 27th 05 07:39 PM |
| Advice on rebuilding a '31 Chevy Coupe engine | samcfadden | Antique cars | 3 | October 10th 04 06:01 AM |
| Im looking for a 454 Engine and 1968 Chevy Nova Parts in Ca | Dillon | Antique cars | 2 | April 28th 04 09:35 PM |
| Buying 1955 Chevy 210 4-door, comments wanted | Alex | Antique cars | 1 | December 2nd 03 04:12 PM |
| WTB: Chevy Trans and Overdrive | Tom Kieffer | Antique cars | 0 | November 14th 03 01:45 PM |
Linear Mode
