If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#3
|
|||
|
|||
Thanks. That's what I was hoping (except for the "pricy" part). Right now
the only thing that suffers is gas mileage, but I'm guessing that the fuel pressure accumulator will be unable to hold pressure because of this and hot starts may become a problem down the road? There's also, of course, a school of thought that says you should minimize the number of components ****ing fuel around under the hood... The apparent sealing on two of the regulator holes looks so cheesy. Theo > I had this happen to my 90 Fox. The regulator is a sealed (supposed to be) > unit. It has to be replaced. They're pricier than they look too. I think > I paid like $125 for it. > > That said, It's a 5 minute job to replace it. Just 2 screws and a wire > to unplug. Save the O-rings from the old one unless they look damaged. > > ...Sean. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2 springs on A2 brake pressure regulator | Mr.Eddy | VW water cooled | 20 | December 6th 04 10:21 PM |
Nissan truck vg30e fuel pressure regulator location? | Victor | 4x4 | 4 | November 16th 04 06:12 PM |
76 Difficult Cold Starts | daveo76 | Corvette | 22 | September 9th 04 12:54 AM |