If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
speed fastener brands
While working on my truck recently I removed some of the plastic push-
in fasteners that hold the rubber-like material that separates the wheel well from the engine compartment. I was doing this to get room to work on a part (O2 sensor), and noticed that a convenient bonus is much easier access to the oil filter. It occurred to me that maybe it would be a good idea to replace the non-reusable push-in fasteners that take effort to yank out, with some sort of speed fastener that is reusable and very easy to install and remove. I've seen them but I can't recall the brands or what keywords to search for. Any tips? Thanks, Dave '95 Dakota V8 |
Ads |
#2
|
|||
|
|||
speed fastener brands
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
change oil brands.. | Cal[_1_] | Jeep | 11 | September 24th 06 08:46 PM |
Mixing tire brands? | Kevin Oberle | BMW | 5 | May 23rd 06 04:11 AM |
Adding Oil - Can't mix brands?? | Rich Grise | Technology | 67 | October 14th 05 07:14 PM |
Front brake disc fastener, Golf 4/A3 | Chris Bartram | Audi | 0 | April 7th 05 06:38 PM |
Can you use different tire brands? | [email protected] | General | 5 | April 1st 05 03:31 PM |