If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
95 Passat VR6 DTC erase?
I'd like to erase the DTC codes on my 95 Passat VR6 (OBDI).
Right now when I check for codes (ignition on, jump 4-15 for 3 secs, repeat) it has codes 1344 (secondary air), and the one for the impluse sensor. I try to erase all codes by connecting the two pins then turning the ignition on and disconnecting after 5 seconds, but then I get all kinds of other codes beginning with four. After a while cycling through these I get a clicking and then on the next code some pump starting up, at which point I turn the ignition off before something irreversible happens. I got the erase procedure from the Bentley for VR6 in the Golf and Jetta. Is the Passat any different? Thanks, Guido |
#2
|
|||
|
|||
You need to fix the issue first, otherwise the MIL will come back on in a
few days. Or if you fix the issue and it doesn't happen again the MIL will go out in a few days. "malabo" > wrote in message oups.com... > I'd like to erase the DTC codes on my 95 Passat VR6 (OBDI). > > Right now when I check for codes (ignition on, jump 4-15 for 3 secs, > repeat) it has codes 1344 (secondary air), and the one for the impluse > sensor. > > I try to erase all codes by connecting the two pins then turning the > ignition on and disconnecting after 5 seconds, but then I get all kinds > of other codes beginning with four. After a while cycling through > these I get a clicking and then on the next code some pump starting up, > at which point I turn the ignition off before something irreversible > happens. > > I got the erase procedure from the Bentley for VR6 in the Golf and > Jetta. Is the Passat any different? > > Thanks, > > Guido > |
#3
|
|||
|
|||
The MIL light was intermittent, but it has stayed off for the past few
days since I changed the impulse sensor ($50). The DTC memory still shows the code though. I don't know how long it remembers everything that ever went wrong so I don't want to be chasing an old fault that no longer exists. I'd like to delete all the faults from memory and start over. Is there any way to do that? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
96 Passat GLS. Starter cranks but engine won't start | elms88 | VW water cooled | 9 | April 7th 05 12:33 PM |
passat cabin space | Alex Lazarevich | VW water cooled | 6 | December 23rd 04 06:03 PM |
Passat or New Passat? | Jeff Bailey | VW water cooled | 11 | October 16th 04 06:33 PM |