If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
torque specs for 1980 L-82
Hi,
Anyone know the valve cover torque specs for 1980 L-82 motor? Thanks |
Ads |
#2
|
|||
|
|||
hello i dont have the manual right he but i'm sure its >10foot pounds
if it was me a 1/4 ratchet and snug it down and recheck after 300-500 miles |
#3
|
|||
|
|||
"Mike" > wrote in message
... > Hi, > Anyone know the valve cover torque specs for 1980 L-82 > motor? > Thanks > Not sure about the 80 / L-82 but my 84 C-4 manual states Rocker Arm Cover Torque Specs W/Gasket = 80 to 120 in-lb WO / Gasket = 50 in-lb seems a little much to me though. -- "Key" |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
TORQUE SPECS | william grod via CarKB.com | Technology | 0 | May 15th 05 03:10 PM |
torque wrench calibration | [email protected] | Technology | 7 | December 20th 04 06:47 PM |
i need specs on torque for a chrysler new yorker block | Rhonda | Chrysler | 0 | October 29th 04 08:15 PM |
Why/How do diesels deliver *less* power but *more* torque? | [email protected] | General | 2 | September 15th 04 11:39 PM |