If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
91 civic upper balljoint
Does anyone know if the balljoint can be pressed out or if the complete
upper arm needs to be replaced? |
Ads |
#2
|
|||
|
|||
Buy the whole arm. I've had joints pressed in come loose when they
shouldnt have. I've also had the rubber come apart in the joints that connect the arm to the strut tower. -SP wrote: > Does anyone know if the balljoint can be pressed out or if the complete > upper arm needs to be replaced? > |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Civic Hybrid | [email protected] | Honda | 8 | December 12th 04 04:38 PM |
1971 Alfa Spider 1750 - Front upper control arm locating washers... | SteveC | Alfa Romeo | 11 | December 2nd 04 03:52 PM |
1997 Honda Civic: Axle and Lower Ball Joint Replacement Notes | Backpacker | Honda | 2 | November 18th 04 02:52 AM |
'91 Civic Si radiator upper tank split | Paul Banchero | Honda | 5 | November 16th 04 02:42 AM |