If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Rochester 4gc accelerator pump intake
I'm rebuilding a 4gc for my 327 powered 1963 Impala and have a
question about the pump intake ball. My carb didn't have one in the pump well but my rebuild kit contained a replacement. How can I tell if my carb uses the intake ball in the pump well? It looks like the bowl has a casting for the intake strainer but can't tell much about the bottom of the pump well. Thanks, Todd |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Does Anyone Know About These Aftermarket Cold Air Intake Upgrades... | The Scarlet Pimpernel | Audi | 6 | December 8th 04 01:36 AM |
Rochester F.I. Repairs | Bruce | Corvette | 0 | August 31st 04 07:20 PM |
2.5 L EFI Intake Manifold - Donavan's Suggestion | Andrew Perlow | Dodge | 2 | August 20th 04 10:11 PM |
Need Intake Maniford for Weber Carbs (1984 Spider Volace) | r.amber | Alfa Romeo | 0 | June 19th 04 10:28 PM |