A Cars forum. AutoBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AutoBanter forum » Auto makers » Chrysler
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Durango engine trouble



 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #6  
Old July 24th 05, 01:55 PM
Peter
external usenet poster
 
Posts: n/a
Default

> 99 Durango 5.9L has started behaving really weird. It starts up more or
> less fine (have to crank it more than usual), and will idle fine. When I
> floor it under load RPMs won't go over 2-3K, it starts coughing, and idles
> very roughly, then stalls (but sometimes will recover to smooth idle). I
> hooked up ODB scantool, and all sensors seem to be in working order.
> Whenever it starts stalling oxy sensor shows lean mix, and ignition
> advance fluctuates wildly between 10-25 degrees. No error codes. I even
> reset PCM by disconnecting battery - no joy.
>
> I'm thinking ignition trouble... had all wires, distributor cap and coil
> replaced recently with Accel hi-perf components... could it have something
> to do with this???


You guys were all wrong

It was the coil

No air bubbles in fuel as far as I can tell ) Fuel pump is fine, too.

Swapped back OEM coil, and it runs as new. I also measured primary
resistance on both coils, about 22Ohms on both... dunno how can I measure
secondary winding. My idle is just a tad rough now - which was the reason
why I 'upgraded' to Accel in the first place.

Now, I wonder how on earth can faulty coil account for smooth idle at first,
then spluttering/missing during acceleration, and finally settle down to
very rough idle? My only guess would be cross-induction caused by higher
voltage... there actually is TSB out for 99 Durango covering ignition wires
cross-induction. When I swapped back the original coil voltage went down and
cross-induction stoppped. If so, why did it run just fine with Accel for
several months???

Peter




 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
rec.autos.makers.chrysler FAQ, Part 1/6 Dr. David Zatz Chrysler 5 July 10th 05 05:24 AM
rec.autos.makers.chrysler FAQ, Part 1/6 Dr. David Zatz Chrysler 5 June 24th 05 05:27 AM
rec.autos.makers.chrysler FAQ, Part 1/6 Dr. David Zatz Chrysler 5 June 8th 05 05:28 AM
rec.autos.makers.chrysler FAQ, Part 1/6 Dr. David Zatz Chrysler 5 May 24th 05 05:27 AM
rec.autos.makers.chrysler FAQ, Part 1/6 Dr. David Zatz Chrysler 7 February 1st 05 02:43 PM


All times are GMT +1. The time now is 11:07 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 AutoBanter.
The comments are property of their posters.