|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 11th 06, 02:55 AM
posted to rec.autos.makers.jeep+willys
|
|||
|
|||
1990 wrangler 4 wheel drive vacuum line?
I have a 1990 Jeep Wrangler who's vacuum lines have been disconnected.
I need help sorting them out as to what goes where. I think I have most of them connected properly but my 4 wheel drive light is on, but when you ramp up the rpms it goes out. I just need some help getting the lines in their proper places so the Wrangler idles rather than stalling. Thanks for the help Jeremy 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| No Ported Vacuum | steve | Jeep | 38 | November 14th 05 01:58 PM |
| Distributor advances too much | azazel scratch | VW air cooled | 12 | August 5th 05 11:14 PM |
| 62 Impala vacuum advance. | homi | Antique cars | 7 | July 28th 05 10:41 AM |
| Question Caravan all wheel drive | shields | Dodge | 2 | May 18th 04 01:30 AM |
Threaded Mode