If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#6
|
|||
|
|||
jim beam > wrote in
: >> > try not to chase if you can avoid it. if you jack the arm up into > position and use the right bolt, the one with the rounded end, you > should be able to get it in ok. the jacking bit is the key. one > time, i even dropped the two big pivot bolts back off to make it > easier to get a difficult top arm in. once located & loosely bolted, > getting the pivot bolts back was fairly straight forward. do the one > with the elongated slot first. > By the way, I tried a bolt from the other side and the same thing happened, so I'm sure there's a burr in there somewhere. -- TeGGeR® The Unofficial Honda/Acura FAQ www.tegger.com/hondafaq/ |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
leaf springs | [email protected] | Corvette | 3 | March 10th 05 10:42 PM |
'88 Wagoneer rear suspension | mike92105 | Jeep | 8 | December 4th 04 06:41 PM |
New *FREE* Corvette Discussion Forum | JLA ENTERPRISES TECHNOLOGIES INTEGRATION | Corvette | 12 | November 30th 04 06:36 PM |
Manual rear air suspension | Mark Carroll | General | 1 | March 17th 04 03:14 PM |