|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
May 9th 05, 05:13 PM
|
|||
|
|||
Rattling Noise In Wheel Area
I have a loud rattling noise that comes from my left rear wheel area when I
go over bumps or rough areas in the road. The rougher the road the louder the rattle, but mysteriously the rattle disappears if I have the brakes pressed even slightly. Does anyone have any speculation as to what this might be? I can't imagine what would cause it not to happen if the brakes are applied. Thanks in advance! I have a 1994 325ic. 
|
| Ads |
|
#2
May 9th 05, 06:08 PM
|
|||
|
|||
|
I'm gonna go out on a limb here, you have worn suspension bushings, and when
you apply the brakes the noise goes away because you are efrfectively binding the suspension against the 4000 pounds of vehicle. If the vehicle is moving forward, and the brakes are applied, then the suspension is going to be pulled rearward and it will bind against the fixed points of the undercarriage. When you release the brakes, the suspension can flop around unrestrained, and you hear this as a rattle. Replacing the suspension bushings should solve your complaints. "Dutch Buckhead" > wrote in message ... > I have a loud rattling noise that comes from my left rear wheel area when I > go over bumps or rough areas in the road. The rougher the road the louder > the rattle, but mysteriously the rattle disappears if I have the brakes > pressed even slightly. Does anyone have any speculation as to what this > might be? I can't imagine what would cause it not to happen if the brakes > are applied. Thanks in advance! I have a 1994 325ic. > >
|
|
#3
May 9th 05, 06:45 PM
|
|||
|
|||
|
Dutch Buckhead wrote:
> I have a loud rattling noise that comes from my left rear wheel area when I > go over bumps or rough areas in the road. The rougher the road the louder > the rattle, but mysteriously the rattle disappears if I have the brakes > pressed even slightly. Does anyone have any speculation as to what this > might be? I can't imagine what would cause it not to happen if the brakes > are applied. Thanks in advance! I have a 1994 325ic. > > Upper shock mount. -Fred W
|
|
#4
May 9th 05, 06:48 PM
|
|||
|
|||
|
Jeff Strickland wrote:
> I'm gonna go out on a limb here, you have worn suspension bushings, and when > you apply the brakes the noise goes away because you are efrfectively > binding the suspension against the 4000 pounds of vehicle. > > If the vehicle is moving forward, and the brakes are applied, then the > suspension is going to be pulled rearward and it will bind against the fixed > points of the undercarriage. When you release the brakes, the suspension can > flop around unrestrained, and you hear this as a rattle. Replacing the > suspension bushings should solve your complaints. > Exactly. Thanks for typing all that in so I don't have to... Except it is the upper shock mount that is bad, but all the other stuff you said applies. ;-) -Fred W
|
|
#5
May 9th 05, 07:49 PM
|
|||
|
|||
|
"Malt_Hound" > wrote in message ... > Jeff Strickland wrote: > > I'm gonna go out on a limb here, you have worn suspension bushings, and when > > you apply the brakes the noise goes away because you are efrfectively > > binding the suspension against the 4000 pounds of vehicle. > > > > If the vehicle is moving forward, and the brakes are applied, then the > > suspension is going to be pulled rearward and it will bind against the fixed > > points of the undercarriage. When you release the brakes, the suspension can > > flop around unrestrained, and you hear this as a rattle. Replacing the > > suspension bushings should solve your complaints. > > > > Exactly. Thanks for typing all that in so I don't have to... > > Except it is the upper shock mount that is bad, but all the other stuff > you said applies. ;-) > Good call. I wouldn't have known that, but I follow the reasoning. I would have found it eventually after looking at all of the other bushings first.
|
|
#6
May 10th 05, 02:49 AM
|
|||
|
|||
|
Jeff Strickland wrote:
> "Malt_Hound" > wrote in message > ... > >>Jeff Strickland wrote: >> >>>I'm gonna go out on a limb here, you have worn suspension bushings, and > > when > >>>you apply the brakes the noise goes away because you are efrfectively >>>binding the suspension against the 4000 pounds of vehicle. >>> >>>If the vehicle is moving forward, and the brakes are applied, then the >>>suspension is going to be pulled rearward and it will bind against the > > fixed > >>>points of the undercarriage. When you release the brakes, the suspension > > can > >>>flop around unrestrained, and you hear this as a rattle. Replacing the >>>suspension bushings should solve your complaints. >>> >> >>Exactly. Thanks for typing all that in so I don't have to... >> >>Except it is the upper shock mount that is bad, but all the other stuff >>you said applies. ;-) >> > > > > Good call. I wouldn't have known that, but I follow the reasoning. I would > have found it eventually after looking at all of the other bushings first. > > > My 1997 528i made the same noise. I found out that the little tangs on the back of the brake pads were not bent out enough to prevent them from rattling against the pistons and calipers. A few minutes with a pliers at each caliper fixed it.
|
|
#7
May 10th 05, 04:19 PM
|
|||
|
|||
|
Tom Wright wrote:
> Jeff Strickland wrote: > >> "Malt_Hound" > wrote in message >> ... >> >>> Jeff Strickland wrote: >>> >>>> I'm gonna go out on a limb here, you have worn suspension bushings, and >> >> >> when >> >>>> you apply the brakes the noise goes away because you are efrfectively >>>> binding the suspension against the 4000 pounds of vehicle. >>>> >>>> If the vehicle is moving forward, and the brakes are applied, then the >>>> suspension is going to be pulled rearward and it will bind against the >> >> >> fixed >> >>>> points of the undercarriage. When you release the brakes, the >>>> suspension >> >> >> can >> >>>> flop around unrestrained, and you hear this as a rattle. Replacing the >>>> suspension bushings should solve your complaints. >>>> >>> >>> Exactly. Thanks for typing all that in so I don't have to... >>> >>> Except it is the upper shock mount that is bad, but all the other stuff >>> you said applies. ;-) >>> >> >> >> >> Good call. I wouldn't have known that, but I follow the reasoning. I >> would >> have found it eventually after looking at all of the other bushings >> first. >> >> >> > My 1997 528i made the same noise. I found out that the little tangs on > the back of the brake pads were not bent out enough to prevent them from > rattling against the pistons and calipers. A few minutes with a pliers > at each caliper fixed it. Ack!! I just reread the OP and sure enough he said the noise was coming from the wheel area. I thought he said it was coming from the rear as in the shock mounts. If it is in fact a rattling and not clunking I would also suspect the brake pads are flopping around in the calipers. -Fred W
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 2 | April 22nd 05 05:32 AM |
| rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 7 | February 1st 05 01:43 PM |
| rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | November 1st 04 05:24 AM |
| rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | October 16th 04 05:28 AM |
| 96 Land Rover Discovery : Diagnosing High Pitched Squeal Wheel Noise ??? | Zach Bower | 4x4 | 2 | August 27th 04 06:16 AM |
Linear Mode
