|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
June 21st 05, 12:07 AM
|
|||
|
|||
SW-99 A/C problem
I have problem with my A/C - it is not cool enough.
Originally I thought that I have missing some Freon. I did some diagnostics already: 1. A/C compressor is running 2. fan is running 3. Freon pressure is correct - at the top of the green zone at 2000 RPM Any help would be appreciated. Thanks 
|
| Ads |
|
#2
June 21st 05, 03:57 AM
|
|||
|
|||
|
You want the low pressure side to read about 30 psi for the best cooling
dont know where that is on your green zone but you probably want it on the lower end of that green zone, sounds like you are over charged !
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 98 Explorer - Cold Starting/ Idle Problem | tj | Ford Explorer | 6 | March 16th 05 03:22 AM |
| rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | December 18th 04 05:15 AM |
| rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | December 2nd 04 05:19 AM |
| New *FREE* Corvette Discussion Forum | JLA ENTERPRISES TECHNOLOGIES INTEGRATION | Corvette | 12 | November 30th 04 06:36 PM |
| 87 TBI Suburban bog / acceleration problem | Michael Vosk | 4x4 | 8 | September 29th 04 04:55 AM |
Linear Mode
