If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
96 SC2 shakes at idle
My 96 SC2 seems to be sending a lot of engine vibration through the
frame at idle. You can feel it in the seat and the interior rattles. I've replaced the hanger mount and the tranny mount. I've checked both torque mounts and they look good. Where else can I look for where this vibration is being transmitted? -Robert |
Ads |
#2
|
|||
|
|||
When was the vehicle last tuned with new plugs? How old are the wires?
When was the throttle body last thoroughly cleaned? Bob "Robert M. Gary" > wrote in message ups.com... > My 96 SC2 seems to be sending a lot of engine vibration through the > frame at idle. You can feel it in the seat and the interior rattles. > I've replaced the hanger mount and the tranny mount. I've checked both > torque mounts and they look good. Where else can I look for where this > vibration is being transmitted? > > -Robert > |
#3
|
|||
|
|||
yes, but the engine isn't the problem. The engine itself doesn't seem
to be doing anything unusual, just the normal amount of small vibration any engine gives off. The problem is that this isn't suppose to make it to the cabin. The reason there is no metal to metal contact between the engine and the body is just to prevent this. Somewhere I must have contact. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 5 | May 24th 05 05:27 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 5 | May 8th 05 05:29 AM |
Rough Idle (87 Toyota Celica) | Thomas Hildebrandt | Technology | 0 | March 8th 05 10:46 PM |
Accord idle hunting | [email protected] | Honda | 0 | January 11th 05 03:44 PM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | November 16th 04 05:28 AM |