If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
how to remove a radio from 2004 Chevy full size Truck??
|
Ads |
#2
|
|||
|
|||
timm > wrote in
nk.net: > hello, > is there anybody that knows the details of how to remove > the factory radio from the dash of an 04 Chev dashboard. > > thanks, > tim > > > > Leave it unlocked and your local stereo thief will happily remove it for you.. free of charge. Std radio Remove the cluster bezel. Remove the 3 screws (1). Pull out the radio assembly slightly in other to gain access to the connectors. Disconnect the wire connectors. Disconnect the coaxial cable from the radio. Remove the radio assembly from the I/P. Installation Procedure Connect the coaxial cable to the radio. Connect the wire connectors. Push in the radio assembly in the opening in order to install the screws. Install the 3 screws (1). Tighten Tighten the screws to 1.6 N·m (14 lb in). Install the cluster bezel. . Calibrate the new radio assembly. Digital radio Removal Procedure Important: Do NOT swap digital radio receivers between vehicles. Swapping digital receivers between vehicles will activate the digital radio Theftlock®, and "XM Theftlock®" will display. Remove the right side junction block from the instrument panel (I/P). Do not disconnect the electrical connectors. Lower the I/P compartment door to the full open position. From the junction block opening, remove the 2 retaining screws. Pull the receiver and bracket assembly from the I/P compartment opening. Disconnect the wire connector (1). Disconnect the coaxial cables from the receiver. Remove the receiver and bracket assembly from the I/P. Installation Procedure Connect the coaxial cables. Connect the wire connector (1). Install the receiver and bracket assembly to the I/P. Install the 2 retaining screws. Tighten Tighten the screws to 1.6 N·m (14 lb in). Install the right side junction block to the I/P. Close the I/P compartment door. Perform the setup procedure for the digital radio receiver. Refer to Digital Radio Receiver Setup . Important After replacement of an XM Radio receiver, call XM Radio to deactivate the receiver that has been removed from the vehicle and activate the new XM Radio receiver. The vehicle must be parked outside in an open area within 24 hours after an activation call. Turn the radio on, tune to the XM channel 0, and record the radio ID from the radio. The ID will be needed for activation of the new receiver. Call XM Radio at 1-800-556-3600 to deactivate the faulty receiver and activate the new receiver. Park the vehicle outside in an area with an unobstructed view of the southern sky. Leave the vehicle outside with the ignition switch in the ACC position and the radio turned ON for 30 minutes to activate XM service. Once activated the radio will receive the remaining XM Radio channels. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Fitting a full size spare in an Allroad | Gordon | Audi | 0 | January 18th 05 01:42 AM |
Free: Bedliner and topper for full size Dodge | Bruce Williams | Dodge | 0 | August 20th 04 02:13 PM |
FS: Bed Liner for 98 Dodge Full Size Bed | TranSurgeon | Dodge | 1 | August 10th 04 09:30 PM |
Help: 1989 Full Size Chevy Blazer U-Joints. | Rocky | 4x4 | 2 | January 20th 04 01:49 PM |