If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Correct lube for window channel?
The window regulator failed on my 93 Nissan Sentra, probably because I cleaned the driver's window channel (2-dr) so well that the glass bound up and the cable failed. I think I can install a new regulator, but what do I lube the channel with to prevent another problem? The passenger window is almost never used, but probably needs help too. I'm posting this to several NGs because a.a.nissan is a really slow group these days. Thanks, Jm |
Ads |
#2
|
|||
|
|||
Correct lube for window channel?
"DemoDisk" > wrote in message news:WJKdnVT5T5IFWQvWnZ2dnUVZ_hSdnZ2d@yournetplus. com... > > The window regulator failed on my 93 Nissan Sentra, probably because I > cleaned the driver's window channel (2-dr) so well that the glass bound > up and the cable failed. > > I think I can install a new regulator, but what do I lube the channel > with to prevent another problem? The passenger window is almost never > used, but probably needs help too. > > I'm posting this to several NGs because a.a.nissan is a really slow > group these days. > > Thanks, > Jm If you are talking about the channel in the window frame, I'd use a silicone lubricant because the silicone doesn't cause the rubber to deteriorate more quickly. The channel in the door itself could be lubricated with lithium grease if it is not lined with rubber. -- Ray O (correct punctuation to reply) |
#3
|
|||
|
|||
Correct lube for window channel?
"Ray O" > wrote in message ... > > "DemoDisk" > wrote in message > news:WJKdnVT5T5IFWQvWnZ2dnUVZ_hSdnZ2d@yournetplus. com... > > > > The window regulator failed on my 93 Nissan Sentra, probably because I > > cleaned the driver's window channel (2-dr) so well that the glass bound > > up and the cable failed. > > > > I think I can install a new regulator, but what do I lube the channel > > with to prevent another problem? The passenger window is almost never > > used, but probably needs help too. > > > > I'm posting this to several NGs because a.a.nissan is a really slow > > group these days. > > > > Thanks, > > Jm > > > If you are talking about the channel in the window frame, I'd use a silicone > lubricant because the silicone doesn't cause the rubber to deteriorate more > quickly. > > The channel in the door itself could be lubricated with lithium grease if it > is not lined with rubber. > Thanks, Ray |
#4
|
|||
|
|||
Correct lube for window channel?
"DemoDisk" > wrote in message news:0JednSFvv69uSwvWnZ2dnUVZ_uudnZ2d@yournetplus. com... > > "Ray O" > wrote in message > ... >> >> "DemoDisk" > wrote in message >> news:WJKdnVT5T5IFWQvWnZ2dnUVZ_hSdnZ2d@yournetplus. com... >> > >> > The window regulator failed on my 93 Nissan Sentra, probably because > I >> > cleaned the driver's window channel (2-dr) so well that the glass > bound >> > up and the cable failed. >> > >> > I think I can install a new regulator, but what do I lube the > channel >> > with to prevent another problem? The passenger window is almost > never >> > used, but probably needs help too. >> > >> > I'm posting this to several NGs because a.a.nissan is a really slow >> > group these days. >> > >> > Thanks, >> > Jm >> >> >> If you are talking about the channel in the window frame, I'd use a > silicone >> lubricant because the silicone doesn't cause the rubber to deteriorate > more >> quickly. >> >> The channel in the door itself could be lubricated with lithium grease > if it >> is not lined with rubber. >> > > Thanks, Ray > You're welcome. By the way, the silicone lubricant does not last very long, so you may have to re-apply once or twice a year. If you want something that lasts longer but is pretty messy, you can use soap-based brake caliper grease. -- Ray O (correct punctuation to reply) |
#5
|
|||
|
|||
Correct lube for window channel?
"DemoDisk" > wrote in message news:WJKdnVT5T5IFWQvWnZ2dnUVZ_hSdnZ2d@yournetplus. com... > > The window regulator failed on my 93 Nissan Sentra, probably because I > cleaned the driver's window channel (2-dr) so well that the glass bound > up and the cable failed. > > I think I can install a new regulator, but what do I lube the channel > with to prevent another problem? The passenger window is almost never > used, but probably needs help too. > > I'm posting this to several NGs because a.a.nissan is a really slow > group these days. > > Thanks, > Jm > > The channel that the glass slides in is not lubricated. The various channels of the regulator itself are lubricated, but not the chanel for the glass. This needs to be clean, My guess is that your 1993 Sentra window regulator simply wore out. A typical construction is that there is a stirng of balls that is pushed and pulled through a guide and is connected to the window. As the motor pushes and pulls the balls, the window goes up and down. The string of balls will break over time. There are variants that involve scissor mechanism to raise and lower the window, but these are generally found in older cars. In any case, the glass should slide freely in a clean track. |
#6
|
|||
|
|||
Correct lube for window channel?
"Jeff Strickland" > wrote in message ... > > "DemoDisk" > wrote in message > news:WJKdnVT5T5IFWQvWnZ2dnUVZ_hSdnZ2d@yournetplus. com... >> >> The window regulator failed on my 93 Nissan Sentra, probably because I >> cleaned the driver's window channel (2-dr) so well that the glass bound >> up and the cable failed. >> >> I think I can install a new regulator, but what do I lube the channel >> with to prevent another problem? The passenger window is almost never >> used, but probably needs help too. >> >> I'm posting this to several NGs because a.a.nissan is a really slow >> group these days. >> >> Thanks, >> Jm >> >> > > The channel that the glass slides in is not lubricated. The various > channels of the regulator itself are lubricated, but not the chanel for > the glass. This needs to be clean, > > My guess is that your 1993 Sentra window regulator simply wore out. > > A typical construction is that there is a stirng of balls that is pushed > and pulled through a guide and is connected to the window. As the motor > pushes and pulls the balls, the window goes up and down. The string of > balls will break over time. There are variants that involve scissor > mechanism to raise and lower the window, but these are generally found in > older cars. > > In any case, the glass should slide freely in a clean track. > I'd bet that the OP's car's setup doesn't have the string of balls setup. The more common setup is having the motor mounted directly to the regulator instead of having a weak link in between, or a cable that pushes and pulls on the regulator like the old fashioned remote mirrors. -- Ray O (correct punctuation to reply) |
#7
|
|||
|
|||
Correct lube for window channel?
"Jeff Strickland" > wrote in message ... > > "DemoDisk" > wrote in message > news:WJKdnVT5T5IFWQvWnZ2dnUVZ_hSdnZ2d@yournetplus. com... > > > > The window regulator failed on my 93 Nissan Sentra, probably because I > > cleaned the driver's window channel (2-dr) so well that the glass bound > > up and the cable failed. > > > > I think I can install a new regulator, but what do I lube the channel > > with to prevent another problem? The passenger window is almost never > > used, but probably needs help too. > > > > I'm posting this to several NGs because a.a.nissan is a really slow > > group these days. > > > > Thanks, > > Jm > > > > > > The channel that the glass slides in is not lubricated. The various channels > of the regulator itself are lubricated, but not the chanel for the glass. > This needs to be clean, > > My guess is that your 1993 Sentra window regulator simply wore out. > > A typical construction is that there is a stirng of balls that is pushed and > pulled through a guide and is connected to the window. As the motor pushes > and pulls the balls, the window goes up and down. The string of balls will > break over time. There are variants that involve scissor mechanism to raise > and lower the window, but these are generally found in older cars. > > In any case, the glass should slide freely in a clean track. No motor in this one; it's manual. Replacement parts online show a cable. But no lubrication? That's interesting. Thanks for your help, Jeff. |
#8
|
|||
|
|||
Correct lube for window channel?
DemoDisk wrote the following:
> "Jeff Strickland" > wrote in message > ... > >> "DemoDisk" > wrote in message >> news:WJKdnVT5T5IFWQvWnZ2dnUVZ_hSdnZ2d@yournetplus. com... >> >>> The window regulator failed on my 93 Nissan Sentra, probably because >>> > I > >>> cleaned the driver's window channel (2-dr) so well that the glass >>> > bound > >>> up and the cable failed. >>> >>> I think I can install a new regulator, but what do I lube the >>> > channel > >>> with to prevent another problem? The passenger window is almost >>> > never > >>> used, but probably needs help too. >>> >>> I'm posting this to several NGs because a.a.nissan is a really slow >>> group these days. >>> >>> Thanks, >>> Jm >>> >>> >>> >> The channel that the glass slides in is not lubricated. The various >> > channels > >> of the regulator itself are lubricated, but not the chanel for the >> > glass. > >> This needs to be clean, >> >> My guess is that your 1993 Sentra window regulator simply wore out. >> >> A typical construction is that there is a stirng of balls that is >> > pushed and > >> pulled through a guide and is connected to the window. As the motor >> > pushes > >> and pulls the balls, the window goes up and down. The string of balls >> > will > >> break over time. There are variants that involve scissor mechanism to >> > raise > >> and lower the window, but these are generally found in older cars. >> >> In any case, the glass should slide freely in a clean track. >> > > No motor in this one; it's manual. Replacement parts online show a > cable. > > But no lubrication? That's interesting. Thanks for your help, Jeff. Whenever I detail my truck, I wipe all the rubber window parts with the tire wet spray on a cloth. -- Bill In Hamptonburgh, NY In the original Orange County. Est. 1683 To email, remove the double zeroes after @ |
#9
|
|||
|
|||
Correct lube for window channel?
In article > , willshak@
00hvc.rr.com says... > Whenever I detail my truck, I wipe all the rubber window parts with the > tire wet spray on a cloth. The mechanic at the independent shop I use recommended occasionally squirting a little bit of Armor All into the top of each side of the window channel and letting it run down inside. He mentioned it after I had just had the regulator replaced on my driver's side window. Dave |
#10
|
|||
|
|||
Correct lube for window channel?
"Conscience" > wrote in message ... > On 2010-03-11 17:48:26 -0800, Dave Garrett > said: > >> In article > , willshak@ >> 00hvc.rr.com says... >> >>> Whenever I detail my truck, I wipe all the rubber window parts with the >>> tire wet spray on a cloth. >> >> The mechanic at the independent shop I use recommended occasionally >> squirting a little bit of Armor All into the top of each side of the >> window channel and letting it run down inside. He mentioned it after I >> had just had the regulator replaced on my driver's side window. > > Armor All is garbage. Snake oil that rots your tires and anything else to > which it's applied. > > Looks pretty for a while, but have a look at your "brown" tires after a > few days. There's a reason for that. > Armor All is heroin for rubber. You have to keep using it or the rubber dies. And you have to use increasing amounts over time. Cold turkey is bad, but having said that I have no idea what the methadone treatment is. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Window door run channel replacement? | Mark G. | Honda | 4 | August 8th 08 03:16 AM |
'97 525i window channel slipping | Paul[_10_] | BMW | 0 | December 21st 06 09:30 AM |
FSJ rear window lift channel | Tom Simes | Jeep | 2 | October 3rd 05 07:09 PM |
Passenger side window/channel guide help | MSon | Technology | 1 | January 20th 05 04:43 AM |
Window/channel guide help | MSon | 4x4 | 0 | January 19th 05 11:52 PM |