If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Stuck Thermostat
My '94 325i with the M50 motor has started to take a very long time to warm
up. I'm leaning towards a tstat failure, and wanted a second opinion. My office is about a mile from the freeway, my house is 2 miles from the freeway. Last night, from my office, and this morning, the temp remained well below the midrange point on the temp indicator. After about 7 miles on the freeway, the needle finally went to midrange, normally it gets to midrange before I get to the freeway from my house, and it will have reached midrange while sitting in traffic at the metering light to enter the freeway after I leave my office. This is a sudden change in behavior, it has always risen from stone cold to midscale within the first mile or so after being started. I am thinking the tstat is stuck open, so the coolant takes much longer to absorb any heat, therefore the temp indicator tells me that the motor is cold. This is a brand new problem, and I have not had an opportunity to investigate if there is any coolant loss or any of those sorts of issues, but if there was an issue with low coolant, the OBC should have told me about it by now. Can the tstat stick open when the motor is not running, then behave "normally" after operating temp has been reached? What would happen if the tstat remained open long after normal operating temp has been reached? I would think that under a constant stuck open condition, the temp should rise and fall with the load on the motor - if I reduce the load and maintain high airflow, then the temp should drop, if I increase the load by driving faster, then the temp should rise to the peak efficiency of the cooling systgem. |
Ads |
#2
|
|||
|
|||
Yup, same thing happened to my '96 1.9L Z-3!
"Jeff Strickland" > wrote in message ... > My '94 325i with the M50 motor has started to take a very long time to warm > up. I'm leaning towards a tstat failure, and wanted a second opinion. > > My office is about a mile from the freeway, my house is 2 miles from the > freeway. Last night, from my office, and this morning, the temp remained > well below the midrange point on the temp indicator. After about 7 miles on > the freeway, the needle finally went to midrange, normally it gets to > midrange before I get to the freeway from my house, and it will have reached > midrange while sitting in traffic at the metering light to enter the freeway > after I leave my office. This is a sudden change in behavior, it has always > risen from stone cold to midscale within the first mile or so after being > started. > > I am thinking the tstat is stuck open, so the coolant takes much longer to > absorb any heat, therefore the temp indicator tells me that the motor is > cold. This is a brand new problem, and I have not had an opportunity to > investigate if there is any coolant loss or any of those sorts of issues, > but if there was an issue with low coolant, the OBC should have told me > about it by now. > > Can the tstat stick open when the motor is not running, then behave > "normally" after operating temp has been reached? What would happen if the > tstat remained open long after normal operating temp has been reached? I > would think that under a constant stuck open condition, the temp should rise > and fall with the load on the motor - if I reduce the load and maintain high > airflow, then the temp should drop, if I increase the load by driving > faster, then the temp should rise to the peak efficiency of the cooling > systgem. > > > > > > > > |
#3
|
|||
|
|||
Jeff Strickland wrote:
> My '94 325i with the M50 motor has started to take a very long time to warm > up. I'm leaning towards a tstat failure, and wanted a second opinion. > > My office is about a mile from the freeway, my house is 2 miles from the > freeway. Last night, from my office, and this morning, the temp remained > well below the midrange point on the temp indicator. After about 7 miles on > the freeway, the needle finally went to midrange, normally it gets to > midrange before I get to the freeway from my house, and it will have reached > midrange while sitting in traffic at the metering light to enter the freeway > after I leave my office. This is a sudden change in behavior, it has always > risen from stone cold to midscale within the first mile or so after being > started. > > I am thinking the tstat is stuck open, so the coolant takes much longer to > absorb any heat, therefore the temp indicator tells me that the motor is > cold. This is a brand new problem, and I have not had an opportunity to > investigate if there is any coolant loss or any of those sorts of issues, > but if there was an issue with low coolant, the OBC should have told me > about it by now. > > Can the tstat stick open when the motor is not running, then behave > "normally" after operating temp has been reached? What would happen if the > tstat remained open long after normal operating temp has been reached? I > would think that under a constant stuck open condition, the temp should rise > and fall with the load on the motor - if I reduce the load and maintain high > airflow, then the temp should drop, if I increase the load by driving > faster, then the temp should rise to the peak efficiency of the cooling > systgem. Sure sounds like a stuck tstat to me. Remember that it probably stuck while the engine was "heat soaking" after being shut off, so it would stick in the wide open position. How the engine temp behaves while driving now is likely difficult to figure out - you have to estimate whether engine heat load, or airflow is dominating the other one. Guess I'd just replace the tstat. Came home from college one Christmas to find my dad had been driving his car with a stuck tstat, and it was badly carboned up by the time I replaced it. Took quite a bit of driving to blow it out. Frank |
#4
|
|||
|
|||
"Jeff Strickland" > wrote in message ... > My '94 325i with the M50 motor has started to take a very long time to warm > up. I'm leaning towards a tstat failure, and wanted a second opinion. > That is the usual cause of failure to warm up fast enough. > > Can the tstat stick open when the motor is not running, then behave > "normally" after operating temp has been reached? What would happen if the > tstat remained open long after normal operating temp has been reached? I > would think that under a constant stuck open condition, the temp should rise > and fall with the load on the motor - if I reduce the load and maintain high > airflow, then the temp should drop, if I increase the load by driving > faster, then the temp should rise to the peak efficiency of the cooling > systgem. The temp does vary with load; however many of the sensors are located on a cast iron tstat housing which tends to reach an average temp. You won't see much change on such engines. On engines with aluminum blocks, the gauge does go up and down some; you can really see this happening on the Ford 3L V6 and the Ford 4L pushrod V6. You should get the thing checked and replaced. Jim |
#5
|
|||
|
|||
Jeff Strickland wrote:
> My '94 325i with the M50 motor has started to take a very long time to warm > up. I'm leaning towards a tstat failure, and wanted a second opinion. > > My office is about a mile from the freeway, my house is 2 miles from the > freeway. Last night, from my office, and this morning, the temp remained > well below the midrange point on the temp indicator. After about 7 miles on > the freeway, the needle finally went to midrange, normally it gets to > midrange before I get to the freeway from my house, and it will have reached > midrange while sitting in traffic at the metering light to enter the freeway > after I leave my office. This is a sudden change in behavior, it has always > risen from stone cold to midscale within the first mile or so after being > started. > > I am thinking the tstat is stuck open, so the coolant takes much longer to > absorb any heat, therefore the temp indicator tells me that the motor is > cold. This is a brand new problem, and I have not had an opportunity to > investigate if there is any coolant loss or any of those sorts of issues, > but if there was an issue with low coolant, the OBC should have told me > about it by now. > > Can the tstat stick open when the motor is not running, then behave > "normally" after operating temp has been reached? What would happen if the > tstat remained open long after normal operating temp has been reached? I > would think that under a constant stuck open condition, the temp should rise > and fall with the load on the motor - if I reduce the load and maintain high > airflow, then the temp should drop, if I increase the load by driving > faster, then the temp should rise to the peak efficiency of the cooling > systgem. Jeff, As others have said, your symptoms are "classic" for a failed t-stat. I just wanted to add a suggestion that while you are doing the job, consider replacing the black plastic t-stat housing with one of the cast aluminum aftermarket replacements. They are more durable and actually seem to be cheaper than the plastic ones lately. There is also a profile gasket that should be changed, along with the o-ring that usually comes with the new t-stat. Heck, if it were me, Since you're going to be draining some of the coolant anyway, I'd do a full coolant flush & fill if it's been longer than a year since your last one. Assuming that you will be doing the job yourself, check the online prices at www.sasponline.com. NA,JASC, yada, yada... Fred W |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Faulty thermostat? | Jeff | BMW | 4 | June 22nd 17 02:51 AM |
1995 Audi 90 2.8l engine temperature low | Gene Buckwalter | Audi | 12 | December 23rd 04 11:20 PM |
Where is the thermostat located on Audi 90? | ~ ElektraMan ~ | Audi | 1 | October 20th 04 11:23 PM |
e34 530 thermostat | mojo | BMW | 5 | October 3rd 04 09:20 PM |
96 A6 blower regulation flaps gets stuck? (stays cold / warm / whatever) | kons | Audi | 4 | July 7th 04 11:29 PM |