|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
January 4th 04, 09:43 PM
|
|||
|
|||
Engineering problem for you guys
I've got a 400-gallon round galvanized tank (with liner) that I use
for quarantine purposes. I'd like to use some sort of bottom drain setup for it but I'm not sure how to go about it. Not sure if it's a good idea to drill a hole through the side for pipe access. Any suggestions? thx 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Another snail problem | me | Cichlids | 1 | July 7th 04 07:03 PM |
| Livebearer problem | JHudson | General | 6 | December 10th 03 07:14 PM |
| buffer problem | Royce | Reefs | 5 | December 7th 03 04:12 AM |
| Eheim Ecco Problem - Need Urgent Help! | Kristen | Marketplace | 0 | October 27th 03 08:56 PM |
| Eheim Ecco Problem - Need Urgent Help! | Kristen | General | 0 | October 27th 03 08:56 PM |
Threaded Mode