|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 18th 04, 05:06 AM
|
|||
|
|||
New Pump
This is off my post about "Timer / Temperature Controller"...
Everyone told me to be careful using a pond pump due to the metal parts, and sure enough, the pump I was looking at was full of them. The water flow on my tank is no where near what I want it at. For a 100 gallon tank and a 4 foot lift from the sump, are there any suggestions on pump brands and sizes? Also, I know there was a post about a good online store, but I can't seem to find it. Could someone please mention that again? (Anywhere in the USA will work). TIA Ken 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| I have to admit the pump I bought is too big for a 1/2 barrel | Roy | General | 0 | August 30th 04 04:25 AM |
| What size pump??? | GoldLexus | General | 3 | June 16th 04 05:30 PM |
| Have you ever measured real water pump output flow rate? | Pszemol | Reefs | 26 | January 19th 04 04:33 AM |
| pump heat transfer; recommendations ? | Kevin M. Smith | Reefs | 2 | October 11th 03 11:43 PM |
| I need a good water pump for my pond | Carlos Falcon | General | 1 | August 16th 03 02:19 AM |
Threaded Mode