![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
This Sword is pretty large and as I had posted previously appeared to be
pregnant. Now, she seems to have found a spot in the corner of the tank between the glass and an artificial plant patch, has settled on the bottom and just sits there in the same spot. Hasnt moved since yesterday. Other fish come up and bump and touch her and she doesnt move at all. No discoloration or anything else unusual looking about her other than she seems to be gasping. Any ideas on wat could be wrong? TIA J |
#2
|
|||
|
|||
![]()
Hi..
[...] Any ideas on wat could be wrong? Tank size, water parameters, food, disease.. -- cu Marco |
#3
|
|||
|
|||
![]() "Marco Schwarz" wrote in message ... Hi.. [...] Any ideas on wat could be wrong? Tank size, water parameters, food, disease.. -- cu Marco hmmmm..... temp, parasites, constipated, irradiated, playful,tease, 'in the dog house', bashful/shy, dyslexic |
#4
|
|||
|
|||
![]() "Marco Schwarz" wrote in message ... Hi.. [...] Any ideas on wat could be wrong? Tank size, water parameters, food, disease.. -- cu Marco The female sword died. 20 gallon tank. All water parameters are within toleracne except for hardness, the water is a little hard. I didnt see any disease until possibly this morning. My female black molly who also appeared to be pregnant, but its been too long now, no fry, has a white area along her left side from her mouth back down about halfway to the back of her body. She is extra large, swelling. Any ideas on what this could be. One major change I made to the tank was the pump 4 days ago. I had an aqua-clear 40 gpm which then motor died in, then I replaced that with an aqua-tech 20-40 from wal-mart and that stopped pumping so instead of one of the big stores I went to my LFS and she sold me a Cascade 150 (35 gph). COuld this have anything to do with it? |
#5
|
|||
|
|||
![]() JeffinMS wrote: .... I had an aqua-clear 40 gpm which then motor died in, then I replaced that with an aqua-tech 20-40 from wal-mart and that stopped pumping so instead of one of the big stores I went to my LFS and she sold me a Cascade 150 (35 gph). COuld this have anything to do with it? This could certainly be the cause, Jeff. When the faulty pump (filter) was replaced did the filter media (sponge) get changed out too? If so, then the tank had a decreased ability to manage fish waste and the ammonia built up to toxic conditions, if only temporarilly. That could cause any of the normal fish diseases to show up as the fish were in a weakened stressed condition. steve |
#6
|
|||
|
|||
![]() "default" wrote in message oups.com... JeffinMS wrote: ... I had an aqua-clear 40 gpm which then motor died in, then I replaced that with an aqua-tech 20-40 from wal-mart and that stopped pumping so instead of one of the big stores I went to my LFS and she sold me a Cascade 150 (35 gph). COuld this have anything to do with it? This could certainly be the cause, Jeff. When the faulty pump (filter) was replaced did the filter media (sponge) get changed out too? If so, then the tank had a decreased ability to manage fish waste and the ammonia built up to toxic conditions, if only temporarilly. That could cause any of the normal fish diseases to show up as the fish were in a weakened stressed condition. steve The aqua-tech stopped pumping to what it should have been for about a week before I replaced it. The water became a little murky and clearly it was time to replace the filter, which I did with the cascade. When I went from the aqua-clear to the aqua-tech I used the same media until everything was normal. When I went from the aqua-tech to the cascade, I didnt use the same media but replaced it with new, the water is no longer murky, its crystal clear, but I am guessing this is what your talking about with the decreased ability to manage fish waste. So what could this white marks on the side of the black molly be and what can I do about it? TIA J |
#7
|
|||
|
|||
![]() JeffinMS wrote: So what could this white marks on the side of the black molly be and what can I do about it? TIA J I'm not a fish doctor, sorry Jeff. Hopefully someone else will chime in with diagnostic and treatment suggestions. When I have one fish get sick, I take it out of the community tank as soon as I can. steve |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Rec.ponds FAQ | Snooze | General | 0 | May 17th 05 03:05 AM |
Rec.ponds FAQ | Snooze | General | 7 | April 11th 05 07:04 AM |