![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
I would welcome any advice. I am building a pond for the first time, i
is a large pond approx 60 feet by 30 feet and about 6 feet deep in th middle. It has been excavated and now I aim to put a layer of "Teram geotextile (bit like weedblock fabric) followed by about 1 inch of san and then I aim to put down "silage sheet", this is the plastic farmer use to line silage and slurry pits and comes in very large sizes. It i much cheaper than official pond liners. Then I intend to cover th sheet with another layer of geotextile and then sand with patches o gravel for cosmetic effect. It will be trickle filled via a small pum from a stream which comes off the mountains. Questions: anyone els used silage sheet? I'm pretty certain the sheet is UV stable but woul welcome comments and any advice - matt wrigh ----------------------------------------------------------------------- posted via www.GardenBanter.co.uk |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
The 'Aquascape System' has the be the WORST pond system outthere | Glenn | General | 11 | November 17th 03 10:58 PM |
Green Farm Pond | Dave | General | 4 | August 23rd 03 03:07 PM |
question on my pond | RichToyBox | General | 17 | August 1st 03 12:35 AM |
How is your 2003 pond project going??? | Chad | General | 6 | July 28th 03 05:42 PM |