|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 22nd 04, 03:15 AM
|
|||
|
|||
q: Pump Supply
Ok i'm wondering if my main supply pump is 3/4" and if i run 2 elbows
and about 3' of 1" to the supply pump from the sump is that ok? or does it limit the pump? on the output end of the pump i will be going 2" Thanks for any info 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| I have to admit the pump I bought is too big for a 1/2 barrel | Roy | General | 0 | August 30th 04 04:25 AM |
| What size pump??? | GoldLexus | General | 3 | June 16th 04 05:30 PM |
| Have you ever measured real water pump output flow rate? | Pszemol | Reefs | 26 | January 19th 04 04:33 AM |
| pump heat transfer; recommendations ? | Kevin M. Smith | Reefs | 2 | October 11th 03 11:43 PM |
| Pump Confusion | RROLD1 | General | 15 | August 28th 03 05:16 AM |
Threaded Mode