|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#18
March 1st 05, 10:20 PM
|
|||
|
|||
Ok, thanks for all your help. I have very few fish, so my nitrates get
used up very radiply. I normally get 0ppm. But I will watch that very carefully. Thanks again! 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| controlling CO2 levels | John | Plants | 3 | October 29th 04 09:06 PM |
| pH and hardness levels? | Jack Dotson | General | 1 | February 1st 04 01:07 AM |
| Can't get good alkalinity levels | Reef Man | Reefs | 11 | November 17th 03 09:56 AM |
| Alkalinity / Hardness Levels | Peter Pan | Reefs | 5 | October 16th 03 12:41 AM |
| HELP- PH levels | Soup | Reefs | 3 | August 6th 03 05:35 PM |
Threaded Mode