|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
May 23rd 05, 07:39 PM
|
|||
|
|||
Actually, I AM using pressurized CO2... I have some drift wood that's keep
my pH LOW, so I use Alkaline Buffer from SeaChem to "up" the pH.. (It's plant-safe). Troy "jet" wrote in message ups.com... Are you using CO2? Are you using anything else to adjust the pH? The levels you have are fine for most fish. If you are not using pH adjusters then you are running about 8.5 ppm CO2, which may be low depending on how heavily planted the tank is and how much light you are using. 
|
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
