|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#2
June 17th 05, 01:32 AM
|
|||
|
|||
"Lobsang Mack rogers com)" (is.guy atdot wrote in message ... I have a Fluval 404 and it is to the point where I am afraid to touch it. Everytime I break it down for maintenance it is a bugger to restart.....My 103 was a dream...never a problem. I replaced the primer unti and when I try to prime it it still sounds like it is sucking air. The impeller is spinning but no water is moving. ANy ideas? -- ---------- www.fotosbyharvey.ca Little Golden Book That Never Made It: Eggs, Toilet Paper, and Your School I've got two 304s, one primes OK, the other I have to pre-fill with tank water before re-attaching. I don't know if the second one is a lemon or if the difference in the tubing angles makes a difference. I know they will BOTH leak if I'm not real careful putting on the tops. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Question for Fluval + Users | ManWorld42 | General | 2 | October 18th 04 05:41 AM |
| Replacement for Fluval 303? | Harry | General | 15 | April 17th 04 02:12 AM |
| Fluval 404 -- 2 models? | blank | General | 14 | December 31st 03 02:28 AM |
| FS: Fluval 104 Canister Filter (in DFW) | Sandy | Marketplace | 0 | July 29th 03 02:42 PM |
| FS: Fluval 204 Canister Filter (in DFW) | Sandy | Marketplace | 0 | July 29th 03 02:41 PM |
Threaded Mode