![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
Moments before spontaneously combusting Dale Henderson at
was heard opining: "Koi-Lo" writes: "netDenizen" wrote in message .. . Finally, others have explained that you should let a glass of tapwater stand for 24 hours before testing pH, because it may change due to outgassing etc. ================= Ours does. It goes from 7.2 to as high as 7.6 after several hours. I got you beat. My comes out of the tap at 7.0. But if I run an airstone in it for an hour it goes over 8. =========== They run CO2 gas in the lines to help keep scale down. At least that's what I was told. -- Koi-Lo.... frugal ponding since 1995... Aquariums since 1952 My Pond & Aquarium Pages: http://tinyurl.com/9do58 ~~~ }((((o ~~~ }{{{{o ~~~ }(((((o |
#2
|
|||
|
|||
![]()
"Koi-Lo" writes:
Moments before spontaneously combusting Dale Henderson at was heard opining: "Koi-Lo" writes: "netDenizen" wrote in message .. . Finally, others have explained that you should let a glass of tapwater stand for 24 hours before testing pH, because it may change due to outgassing etc. ================= Ours does. It goes from 7.2 to as high as 7.6 after several hours. I got you beat. My comes out of the tap at 7.0. But if I run an airstone in it for an hour it goes over 8. =========== They run CO2 gas in the lines to help keep scale down. At least that's what I was told. I have a well. Well water is notorious for being full of C02 and for being very hard. |
#3
|
|||
|
|||
![]()
On 09 Apr 2006, the world was enlightened by Dale Henderson's opinion
about... "Koi-Lo" writes: Moments before spontaneously combusting Dale Henderson at was heard opining: "Koi-Lo" writes: "netDenizen" wrote in message .. . Finally, others have explained that you should let a glass of tapwater stand for 24 hours before testing pH, because it may change due to outgassing etc. ================= Ours does. It goes from 7.2 to as high as 7.6 after several hours. I got you beat. My comes out of the tap at 7.0. But if I run an airstone in it for an hour it goes over 8. =========== They run CO2 gas in the lines to help keep scale down. At least that's what I was told. I have a well. Well water is notorious for being full of C02 and for being very hard. I used to live in the Poconos in northeast PA and the well water there was extremely soft (1-2 dKH) with a pH of 6.4. No limestone to make the water hard. kev -- Clones are people two. The Eeeevil Cabal's Nine of Spades. Wickeddoll's on-demand FP guru. |
#4
|
|||
|
|||
![]()
kev writes:
I used to live in the Poconos in northeast PA and the well water there was extremely soft (1-2 dKH) with a pH of 6.4. No limestone to make the water hard. kev Actually my father-in-law has a well and his water is extremely soft. I've never tested it but you can tell by feel. |
#5
|
|||
|
|||
![]()
Thank for the help everybody.I can't believe how fast and helpful everyone
here can be:-).I normal wouldn't try to change the PH but I just lost a 8 year old Raphael cat .So I thought it was the Ph.I haven't added anything new,no fertilizers,co2 ,fish ,shells ,plants ,ect... I was doing large water changes but cut them down because I was trying to raise the nitrates to stop the cyanobactiria like Tom Barr says to do. I'm going to test the tank in the morning and at night,(when I got the high reading it was at 9 at night so maybe your right)Then I'll check the tap water after letting it sit overnight. Thanks again all. |
#6
|
|||
|
|||
![]()
Animal wrote:
Thank for the help everybody.I can't believe how fast and helpful everyone here can be:-).I normal wouldn't try to change the PH but I just lost a 8 year old Raphael cat .So I thought it was the Ph.I haven't added anything new,no fertilizers,co2 ,fish ,shells ,plants ,ect... I was doing large water changes but cut them down because I was trying to raise the nitrates to stop the cyanobactiria like Tom Barr says to do. I'm going to test the tank in the morning and at night,(when I got the high reading it was at 9 at night so maybe your right)Then I'll check the tap water after letting it sit overnight. Thanks again all. Is this a planted tank? If so, add KNO3 to raise nitrates. Otherwise it is not a low nitrate issue, it is a dirty gravel issue. -- Put the word aquaria in the subject to reply. Did you read the FAQ? http://faq.thekrib.com |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
lowering pH | Aquarijen | General | 10 | October 14th 04 02:06 PM |
Need help in lowering nitrate and alkalinity levels. | Annaid | Goldfish | 4 | January 12th 04 11:11 AM |
Lowering pH | Jeff & Kathy Brown | General | 32 | July 30th 03 02:19 PM |