|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
May 12th 06, 03:00 PM
posted to rec.ponds
|
|||
|
|||
In pond pump input cover... any ideas?
wrote in message
... Small pump, small milk crate. Large pump, large milk crate. I just attached one layer of furnace filter to the milk crate. When the flow slowed I would pull it out of the pond (turning it off first) and hit it with a high pressure hose on every side. Quick and easy. YMMV That's what I've been doing, but pulling it out every 4-5 days is getting to be a PITA. -- Gareee© (Gary Tabar Jr.) 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Pond pump problem... please help! | Pond Skater | General | 6 | May 7th 05 04:23 PM |
| Pond pump problem... please help! | Pond Skater | General | 1 | May 5th 05 03:33 AM |
| Pond Pump loses its prime in an hour.. each time? see end. I did see a leak in the seal but why would it run in the first place? | Neil | General | 10 | April 20th 04 07:43 PM |
| Help choosing a pump for my new pond.... | Ben Raines | General | 8 | July 25th 03 12:41 PM |
Hybrid Mode
