![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]() "Jim Conklin" wrote in message k.net... Folks I think I'm having a problem getting CO2 to diffuse into my tank. My well water right out of the tap is very soft and acidic: about a pH of 6.2, a KH of 80ppm and a GH of 75. (Perfect for Discus, which I keep.) I have a small CO2 tank connected with silicon tubing. I put the outlet tube into the inlet of my Rena Filstar canister filter. I give the 55 gallon tank about 12 hours of light with two 65 watt compact flourcent bulbs. But I'm still troubled by 'black-green' algae and minimal plant growth. I keep the water at 85F. I fertilize regularly with Trace and Flourish and keep the Nitrate level at 20ppm. I've tried all different types of plants and while they survive and grow a bit, there is no growth such as I see in pictures of other hobbyist's tanks. Any advise or suggestions on how to get the CO2 to stay in the water or what I could be doing wrong is appreciated. From the specifications above above I'd think the plants should be growing out of the tank! Thanks for any help. Jim, What are your CO2 levels, ie. what is your PH level after adding CO2? Where is your spraybar output? How are your Phosphate levels? I have a 55 gallon tall with 2*96 and my plant growth is pretty good. My PH is around 7.8ish in the tank and 6.8 with CO2. I run the CO2 into the venturi input of my Penguin powerheads that I use for RUGF. The Ludwigia and other plants grow like weeds at this CO2 level. I'm currently suffering from a fair amount of GSA (Green Spot Algae), probably due to lack of Nitrates. My Nitrates stay around 10 ppm naturally. |
#2
|
|||
|
|||
![]() Bill Stock wrote: "Jim Conklin" wrote in message k.net... Folks I think I'm having a problem getting CO2 to diffuse into my tank. My well water right out of the tap is very soft and acidic: about a pH of 6.2, a KH of 80ppm and a GH of 75. (Perfect for Discus, which I keep.) I have a small CO2 tank connected with silicon tubing. I put the outlet tube into the inlet of my Rena Filstar canister filter. I give the 55 gallon tank about 12 hours of light with two 65 watt compact flourcent bulbs. But I'm still troubled by 'black-green' algae and minimal plant growth. I keep the water at 85F. I fertilize regularly with Trace and Flourish and keep the Nitrate level at 20ppm. I've tried all different types of plants and while they survive and grow a bit, there is no growth such as I see in pictures of other hobbyist's tanks. Any advise or suggestions on how to get the CO2 to stay in the water or what I could be doing wrong is appreciated. From the specifications above above I'd think the plants should be growing out of the tank! Thanks for any help. Jim, What are your CO2 levels, ie. what is your PH level after adding CO2? Where is your spraybar output? How are your Phosphate levels? I have a 55 gallon tall with 2*96 and my plant growth is pretty good. My PH is around 7.8ish in the tank and 6.8 with CO2. I run the CO2 into the venturi input of my Penguin powerheads that I use for RUGF. The Ludwigia and other plants grow like weeds at this CO2 level. I'm currently suffering from a fair amount of GSA (Green Spot Algae), probably due to lack of Nitrates. My Nitrates stay around 10 ppm naturally. Bill, if you add 1/8 teaspoon 3x a week of KH2PO4 you will watch the tank grow faster and not longer have that hard green spot algae. a 50% weekly water change, Adding 1/4-1/2 teaspoon KNO3, 2-3x a week and something like TMG 10mls 3x a week would address most any issues you may have with growth. Mg is likely the only other item you might need a tad more of(so adding say 1/4 teraspoon of that once a week after the water change will take care of that along with the levels in the tap and the TMG which has a little Mg/K as well. Regards, Tom Barr www.BarrReport.com |
#3
|
|||
|
|||
![]() wrote in message ups.com... Bill Stock wrote: "Jim Conklin" wrote in message k.net... Folks I think I'm having a problem getting CO2 to diffuse into my tank. My well water right out of the tap is very soft and acidic: about a pH of 6.2, a KH of 80ppm and a GH of 75. (Perfect for Discus, which I keep.) I have a small CO2 tank connected with silicon tubing. I put the outlet tube into the inlet of my Rena Filstar canister filter. I give the 55 gallon tank about 12 hours of light with two 65 watt compact flourcent bulbs. But I'm still troubled by 'black-green' algae and minimal plant growth. I keep the water at 85F. I fertilize regularly with Trace and Flourish and keep the Nitrate level at 20ppm. I've tried all different types of plants and while they survive and grow a bit, there is no growth such as I see in pictures of other hobbyist's tanks. Any advise or suggestions on how to get the CO2 to stay in the water or what I could be doing wrong is appreciated. From the specifications above above I'd think the plants should be growing out of the tank! Thanks for any help. Jim, What are your CO2 levels, ie. what is your PH level after adding CO2? Where is your spraybar output? How are your Phosphate levels? I have a 55 gallon tall with 2*96 and my plant growth is pretty good. My PH is around 7.8ish in the tank and 6.8 with CO2. I run the CO2 into the venturi input of my Penguin powerheads that I use for RUGF. The Ludwigia and other plants grow like weeds at this CO2 level. I'm currently suffering from a fair amount of GSA (Green Spot Algae), probably due to lack of Nitrates. My Nitrates stay around 10 ppm naturally. Bill, if you add 1/8 teaspoon 3x a week of KH2PO4 you will watch the tank grow faster and not longer have that hard green spot algae. a 50% weekly water change, Adding 1/4-1/2 teaspoon KNO3, 2-3x a week and something like TMG 10mls 3x a week would address most any issues you may have with growth. Mg is likely the only other item you might need a tad more of(so adding say 1/4 teraspoon of that once a week after the water change will take care of that along with the levels in the tap and the TMG which has a little Mg/K as well. Thanks Tom, I add about 1-2 ppm of Phosphate a week. Water changes are within spec (finally). Not sure about the Mg, I add 25/700*2 Tbsp weekly. (Hmm.. according to the Gaddulator, not nearly enough). I know my KNo3 is on the low side. I really can't complain about the growth though. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
The Successful Aquarium: A Beginners Guide | AuctionCashOnline.com | General | 1 | February 11th 05 02:27 AM |
Chat Week 2003 - Meet Julian Sprung, Martin Moe, Kevin Kohen, TomLang, more... | Jeff Barringer | General | 0 | December 7th 03 05:50 PM |
Chat Week 2003 - Meet Julian Sprung, Martin Moe, Kevin Kohen, TomLang, more... | Jeff Barringer | General | 0 | December 7th 03 05:49 PM |
Chat Week 2003 - Meet Julian Sprung, Martin Moe, Kevin Kohen, TomLang, more... | Jeff Barringer | Reefs | 0 | December 6th 03 05:55 AM |
AquariumHobbyist Chat Week 2003 | Jeff Barringer | Reefs | 0 | December 4th 03 02:21 AM |