|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 8th 06, 05:50 PM
posted to rec.aquaria.freshwater.misc
|
|||
|
|||
Edge supported aquariums
I'll be building a stand for a new 90 gallon drilled tank, so I'm going with
an edge supported design. The whole idea makes me a little nervous to be honest, but it seems fairly common. But I'm wondering how you cushion the edges, since there is no bottom under the tank. I have a sheet of Styrofoam under my present 75 gallon, but this won't work with a bottomless design. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Invisible Edge - Plumbing ? | General | 0 | April 1st 05 07:22 AM | |
| Invisible Edge plumbing setup | General | 0 | March 31st 05 01:37 PM | |
| "Awesome Aquariums" in the news | D.L. | General | 14 | February 1st 05 04:23 AM |
| supporting 20G long by long sides alone | Flying Squirrel | General | 15 | June 12th 04 10:11 PM |
| FS: Misc. Aquariums and Equipment all in new/vgc ...D/FW,also will ship | Dave C | Marketplace | 0 | January 21st 04 08:56 PM |
Threaded Mode