![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
So my question is. After getting a new heater..... Will my cycle be okay
or did I kill all my bacteria to? "James" wrote in message . .. I went out for a movie tonight. When I came home My fish were missing. I found them on the mechanical intake. Water temp was 105. Two dead clowns =( 4 turbo snails Thats one hell of a way to start a hobby... or end it one..... |
#2
|
|||
|
|||
![]()
Give it a week before adding any more fish, and then if
amonia and nitrite are good, then start slowly stocking. Wayne Sallee Wayne's Pets James wrote on 11/6/2006 10:08 PM: So my question is. After getting a new heater..... Will my cycle be okay or did I kill all my bacteria to? "James" wrote in message . .. I went out for a movie tonight. When I came home My fish were missing. I found them on the mechanical intake. Water temp was 105. Two dead clowns =( 4 turbo snails Thats one hell of a way to start a hobby... or end it one..... |
#3
|
|||
|
|||
![]()
ALSO get a therometer, even though the heaters have a setting on top, make
sure when you set the heater at 74degrees that is actually 74 degrees. ( adjust accordingly) "Wayne Sallee" wrote in message nk.net... Give it a week before adding any more fish, and then if amonia and nitrite are good, then start slowly stocking. Wayne Sallee Wayne's Pets James wrote on 11/6/2006 10:08 PM: So my question is. After getting a new heater..... Will my cycle be okay or did I kill all my bacteria to? "James" wrote in message . .. I went out for a movie tonight. When I came home My fish were missing. I found them on the mechanical intake. Water temp was 105. Two dead clowns =( 4 turbo snails Thats one hell of a way to start a hobby... or end it one..... |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Eheim 2126 Thermofilter heater broken | [email protected] | General | 1 | September 26th 06 10:23 AM |
Heater accuracy (Won Brothers)? | Bill Stock | General | 17 | March 11th 05 09:46 AM |
Heater accuracy (Won Brothers)? | Bill Stock | Tech | 17 | March 11th 05 09:46 AM |
When the Heater Breaks.... | Ami . | Goldfish | 10 | January 16th 04 06:57 PM |
Submersable Heater Melted. | Glenn Serpas | General | 2 | December 31st 03 06:19 PM |