|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#5
September 12th 07, 04:50 AM
posted to rec.ponds
|
|||
|
|||
Winterizing Your Pump
"JB" wrote in message ... Reel, I'm guessing then that you haven't had any problem with the seals drying or cracking? That was my main concern with letting the pump dry out. ==================== As far as I know that has not occurred. My old Beckett lasted for years and the rubber seal was still pliable and looked like new. About 2 years ago water did leak in but the screws weren't as tight as they should have been. We used some Vaseline on the seal, tightened the screws and all was well until it developed a dead spot a few weeks ago. -- RM.... Frugal ponding since 1995. rec.ponder since late 1996. My Pond & Aquarium Pages: http://tinyurl.com/9do58 Zone 6. Middle TN USA ~~~~ }((((* ~~~ }{{{{(ö 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Winterizing | clevfunguy | General | 3 | November 1st 06 11:02 PM |
| Winterizing | Capn Courage | General | 3 | October 20th 05 10:07 PM |
| Winterizing | ~ jan jjspond | General | 4 | October 18th 05 05:58 PM |
| Winterizing - Again | Bill Stock | General | 17 | September 28th 04 02:37 PM |
| Winterizing | John Ferman | General | 2 | November 23rd 03 10:31 PM |
Threaded Mode