![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
On Mar 31, 8:35*am, "Steve Heath" sucked a
dick then slowly spoke: wrote in message Ahhhhhhh poor poor asswipe steve can not remember what nyms he uses. Is it August West tomorrow or Suzie Q the pussy boi....Take these ****ing sal****er qurestions and shove them where the sun does not shine dumbass! Therew is no one in these gorups that knows the answers anyhow.............so its all just a lot of **** here. |
#2
|
|||
|
|||
![]()
I accept a 65 top beach tank, 36" long. I am currently application metal halide on it, about it is costing me approx $65.00 a ages just to run the lights, The pumps are added of course. I accept a nice mix of hard and bendable coral. The catechism is what can I alter the metal halides with that will accord me the able lighting for the beach at a greatly bargain electricity cost.
|
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
diy lighting | [email protected] | General | 6 | January 3rd 07 03:38 PM |
Lighting | Joseph | Plants | 4 | December 19th 03 01:44 PM |
Lighting Question -length and interrupted lighting | JHudson | Plants | 3 | December 13th 03 06:22 AM |
lighting | Stef | Goldfish | 4 | November 18th 03 01:29 PM |
lighting help | Troy Bruder | Plants | 8 | October 10th 03 07:32 PM |