![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]() "Michi Henning" wrote in message ... "F_P" wrote in message ... Now I have to decide what to do. Taking the wood off is the most obvious choice, but it implies a mayor change to the tank set-up, which is rather difficult in its current location. Considering that the wood wasn't completely "green", I'd like to know your opinion on the following course of action: 1) add activated carbon to the filter, to remove as much organic matter as possible 2) do large (30% - 50%) weekly water changes 3) dim the light All this waiting for the plants to grow enough to starve the algae of any nutrients. I strongly suspect that your chances of getting your wood to go back to normal are just about zero. I can't think of any way to stop that decay that wouldn't also kill everything else in the tank. You best bet would probably be to get rid of the wood you have now and get hold of some proper driftwood that won't go into decay on you. I agree with Michi. Dried for a couple of years makes it suitable for your fireplace, but aquarium driftwood should be completely dehydrated, and that takes many years in dry conditions. I've used less than perfect wood before, and sometimes I get away with it, and other times it goes into rotting mode and I need to pitch it. The fish would signal distress by the usual signs: loss of appetite, atypical behavior, hanging around the top or bottom where they wouldn't normally be, rapid respiration etc etc. Note that Neons are very poor at providing symptoms for analysis. Their sick stage is usually quite short, going from frisky eating well to dead in a few hours. Very few diseases (ie: NTD) take a long time to kill Neons. Poisoning also usually happens very quickly, but in your case, it might be gradual or not at all, but the elevated potential is there, and Neons are somewhat fragile due to their low body mass. Preparation of that wood would be boiling, then microwaving, then coating with epoxy, and even then, your results might vary if the fibers have softened. I'd pitch it and wait a while before introducing new wood, as the established fungus/mould/algae spores might have a go at whatever you put in there for a while. NetMax Cheers, Michi. -- Michi Henning Ph: +61 4 1118-2700 ZeroC, Inc. http://www.zeroc.com |
#2
|
|||
|
|||
![]()
NetMax wrote:
"Michi Henning" wrote in message I strongly suspect that your chances of getting your wood to go back to normal are just about zero. I can't think of any way to stop that decay that wouldn't also kill everything else in the tank. You best bet would probably be to get rid of the wood you have now and get hold of some proper driftwood that won't go into decay on you. I agree with Michi. Dried for a couple of years makes it suitable for your fireplace, but aquarium driftwood should be completely dehydrated, and that takes many years in dry conditions. I've used less than perfect wood before, and sometimes I get away with it, and other times it goes into rotting mode and I need to pitch it. Ouch! Well, thanks so much for the advice, anyway :- FP |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Cynobacteria/Red Slime Algae: A Success Story (Long) | Bobby Bhamra | General | 8 | May 16th 04 05:25 PM |
Cynobacteria/Red Slime Algae: A Success Story (Long) | Bobby Bhamra | Reefs | 14 | May 16th 04 05:25 PM |
Green algae forming | Iain | Reefs | 8 | May 8th 04 03:35 AM |
Algae ruining hobby for me | Stilgar[bbs.isca.uiowa.edu] | General | 9 | February 10th 04 06:11 AM |
Bookshelf stream | F_P | General | 4 | February 8th 04 07:46 PM |