|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
December 1st 03, 01:55 AM
|
|||
|
|||
Making my own tank??? need help
Hi, I was intersted in making my own tanks... but i have some
questions... 1. What kind of silicon do I use? 2. Where can I get the plastic top and bottom rims that hold the tank together? 3. Any suggestions on how to silicon and how to put the tank together? Any help/suggestions would be greatly appreciated!!! thanks! 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Do I need to get the glass cut on this tank ?? | [email protected] | Tech | 5 | January 26th 04 01:54 AM |
| Making the leap from freswater to Marine | Emily | General | 3 | November 7th 03 02:35 PM |
| Removing ammonia from "baby" fish tank | Tony | General | 7 | September 2nd 03 02:33 AM |
| Advice on my new tank plan | richard reynolds | General | 2 | August 2nd 03 08:08 PM |
| Advice on first marine tank | Lone6Wolfpack | General | 3 | July 15th 03 06:11 PM |
Threaded Mode