![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
![]()
The ventilation is important. I run a small window size exhaust fan spring,
summer and fall in my basement fish room and a dehumidifier the rest of the year. I have considered a heat exchanger, but I haven't purchased one at this point. "Racf" wrote in message ... Last but not least, you should plan for adequate ventilation. A wall or ceiling mounted exhaust fan of suitable size, and also, corresponding vents to allow in fresh air. In a tight room the humidity will be high and everything will be wet....and spills would never dissipate. I forgot this on the earlier post... For vents I like the little cheap plastic ones intended for the end of a central air duct, that allow you to adjust how open or closed it is... Perhaps a bathroom type vent could suck enough air, some of those have heaters in them...but I wonder if there is a thermostat. Of course then the question of where it would be vented to arises. I have two bathrooms in my house. One is vented out a duct and out through the roof, while the other is simply vented to the attic. I guess your local weather pattern will help decide what if anything you will need to do. |
#12
|
|||
|
|||
![]()
I've got one of those industrial window exhaust unit. I could build it
into the wall i'm putting in to separate the room from the rest ofthe garage. I can use a hose to route the intake for the linear air pump from outside the room, to ensure that the air supply into the tanks is always fresh and dry.. I'm in Brampton Ontario, just north west of Toronto.. Winters are pretty cold... On Mon, 4 Aug 2003 13:42:00 -0500, "Racf" wrote: Last but not least, you should plan for adequate ventilation. A wall or ceiling mounted exhaust fan of suitable size, and also, corresponding vents to allow in fresh air. In a tight room the humidity will be high and everything will be wet....and spills would never dissipate. I forgot this on the earlier post... For vents I like the little cheap plastic ones intended for the end of a central air duct, that allow you to adjust how open or closed it is... Perhaps a bathroom type vent could suck enough air, some of those have heaters in them...but I wonder if there is a thermostat. Of course then the question of where it would be vented to arises. I have two bathrooms in my house. One is vented out a duct and out through the roof, while the other is simply vented to the attic. I guess your local weather pattern will help decide what if anything you will need to do. |
#13
|
|||
|
|||
![]() "The Madd Hatter" wrote in message ... I've got one of those industrial window exhaust unit. I could build it into the wall i'm putting in to separate the room from the rest ofthe garage. I can use a hose to route the intake for the linear air pump from outside the room, to ensure that the air supply into the tanks is always fresh and dry.. I'm in Brampton Ontario, just north west of Toronto.. Winters are pretty cold... I didn't even guess you were in that part of the hemisphere, especially when you said there was a cold water faucet in the garage. I guess cold water faucet is a good description. Well, the good news is the slab floor will keep the room nice and cool year round.... I'm down in Champlin MN near Minneapolis, where the winters are a bit more tropical... I guess your garage faucet stem is also a foot long like ours here... |
#14
|
|||
|
|||
![]()
I use a space heater in a well insulated room built in the basement only the aquarium. Some tanks have heaters to meet the warm love of fish, Like a discus, zebra plecos, and paradise fish spawning. A wall-mounted gas gas water heater if you are not cheap, but better long-term goal. I would like to once is not enough space for the vent.
|
#15
|
|||
|
|||
![]()
I advance abrogation the attic as is perhaps abacus a mat to th aisle to abstain slipping. When you do body your racks accomplish abiding th posts are not sitting on the concrete. Some put hockey pucks beneath them. This activity keeps baptize (which will spill) from wicking up th structure.
|
|
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Main Pump is Dead Again - Question with Drilling 55GAL Sump | reefdvr | Reefs | 3 | June 26th 04 08:43 AM |
Main Pump is Dead Again - Question with Drilling 55GAL Sump | reefdvr | Reefs | 1 | June 26th 04 01:56 AM |
Pump, sump and elbow on the intake | Pszemol | Reefs | 6 | January 3rd 04 01:18 AM |
Sump volume and recommended pump discharge | Pszemol | Reefs | 3 | November 7th 03 05:15 AM |
DIY Heating for Sump system | The Madd Hatter | Tech | 7 | August 21st 03 12:51 AM |