Layer of foam on water

No noise whatsoever...

(Keng) wrote in message . com...
No noise whatsoever...

I have an Emperor filter so no store-bought Fluval solution for me.

I spose I could drill a hole in the intake tube, run some tubing to
the top, and let it suck the bubbles...

Just for reference -- for others like myself in the future -- heres a
link for a DIY skimmer: http://www.thekrib.com/Filters/Busko/

It mentions the foam can be caused infreshwater tanks from oils in
fish food or the substrate...

Actually, the surface skimmer came with a couple of adaptors which I
am sure will fit the intake tube you have. On mine, it actually
replaced the whole tube and the plastic 'grill" at the end. Not sure
if this makes any sense, but the skimmer attaches right to the ribbed
tubing for my filter.

You might want to check out your local pet store to see if they have
one and then try to see if the dimensions will work for you before you
drill any holes. Seems like a whole lot of work and retrofitting for
under $20.

The surface skimmer to a couple of adapters, I am sure will suit your intake pipe. On mine, it actually replaces the whole tube and plastic 'roast "at the end. do not know if this does not make sense, but the right emphasis to the skimmer filter out of my ribs.

On mine, it actually replaced the accomplished tube and the artificial 'grill" at the end. Not sure if this makes any sense, but the skimmer attaches appropriate to the ribbed tubing for my filter. You ability wish to analysis out your bounded pet abundance to see if they have one and again try to see if the ambit will plan for you afore you drill any holes.