A Fishkeeping forum. FishKeepingBanter.com

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » FishKeepingBanter.com forum » rec.aquaria » General
Site Map Home Authors List Search Today's Posts Mark Forums Read Web Partners

DIY Coil Denitrator Questions



 
 
Thread Tools Display Modes
  #11  
Old August 2nd 03, 01:17 AM
richard reynolds
external usenet poster
 
Posts: n/a
Default DIY Coil Denitrator Questions

ok 10dkh so a small change but no change with the addition nitrates enough for 200ppm

it would seem to consume them a little (remember 10gallon), but only when its consuming
nitrates. this 10 isnt a cycled tank, it has no source of ammonia/nitrite/nitrate besides
what I added to it. so scaling that up to something usefull with a nitrate source it
probibly does consume alk, and you might expect it to stop as soon as you get to a lower
level in your tank..

--
--
richard reynolds



richard reynolds wrote in message
. ..
i hozed the test by not testing the water after i added the nitrate, though i did test
before adding and alk was basically unchanged, it seemed to change a tad when there was
nitrate to remove, and not at all when there wasnt its still going and I just tested the
KH its at 10 so its a decrease but its also been running a week with nothing in it

once
the stuff i am adding for nitrate desolves completely ill test the kh again see if its
changing the alk

--
--
richard reynolds



Iain Miller wrote in message
...
..... but just to be certain ill test the Kh of a quasi control tank a

10gallon with
nitrate levels of 200ppm i put an already established coil onto it from

another tank. the
Kh was 11dkh its been going sence 16:00pst ill test again at 21:00pst then

sometime
tomorrow and post all the #'s btw its a large coil and will circulate the

tank water in
aprox 2 hours. I might check it then just to see what the #'s come out as,

but wont post
them at that time.


Any results Richard?






  #12  
Old August 2nd 03, 01:53 AM
Iain Miller
external usenet poster
 
Posts: n/a
Default DIY Coil Denitrator Questions


"richard reynolds" wrote in message
. ..
ok 10dkh so a small change but no change with the addition nitrates enough

for 200ppm

it would seem to consume them a little (remember 10gallon), but only when

its consuming
nitrates. this 10 isnt a cycled tank, it has no source of

ammonia/nitrite/nitrate besides
what I added to it. so scaling that up to something usefull with a nitrate

source it
probibly does consume alk, and you might expect it to stop as soon as you

get to a lower
level in your tank..


That makes sense with what I have seen - as my Nitrate levels in the tank
have fallen so the effect on the Kh seems to be less dramatic.
Thanks for doing that - something else learned.

I.


 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 05:37 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 FishKeepingBanter.com.
The comments are property of their posters.